my new sub enclosures

Ok i finished my rear box the other day and got it installed. 2.2cf of air space with a slot port tunes to 32hz.

I am hoping to finish the center console one this week. I decided to change it a little from my original plan. Here is what i started with its 2.15 cf with 2 pvc ports tuned to 32hz. I was planning on using the factory console as is on top but it looked out of place. So I took the top of the factory seat/console apart and removed the padding. I now have to build a top section to the box to hold the factory internals of the console. I hope to have it finished and installed early next week.

What are the dimensions of the console box? What are the length and diameter of the ports?

Nice work!

Looking good! Way to get creative and make it work, plus doesn't seem like you'll be killing too much useable space

jdc, yeah i had a giant box sitting in the back for the last couple of years so it will be nice being able to use that space again.

MPT, I dont remember off the top of my head. I will get you that info. I had a local guy use his calculating software to help me finalize my dimensions. I will get them tonight when i go to carpet it.

BTW here are a couple of shots of the console with the top added to hold the factory center seat/console lid.

Ok finally had time to carpet it. Hopefully i can get it installed this weekend. I just have to trim the rear cup holders.

Looks bitchin, Why so high on the rear one, just for air volume?

yes, i was trying to keep it as flush with the side as possible. It is 2.2 cf inside with a slot port. It sounds great but i might re work it over the winter IF i have time.

That looks good nice work man