Sound Off!!... show off the systems and what you've done

Gotta start off the forum right, so lets see pics of what you got for audio fun inside the trucks. We all spend soo much time in them there's gotta be something to listen too when we get tired of the turbo's song



Here is what I got

Dash houses a 10.4" touch screen for the computer. Right now 120gb HD for movies and music, does my GPS also and anything else I need



Relocated the climate controls to the upfitter switch cubby, and then built this pod for the Alpine 9887 HU, upfitter switches and brake controller.



Front speakers and only speakers, are Polk Audio SR6500 set minus the crossover. Mids in the stock door location and tweeters fiberglassed to the sail panels

[/IMG]

Subwoofer is in the 08 center console. Sub is a Stereo Integrity 12" Mag V4 in roughly 0.93ft^3 sealed box, console with sub (25lbs) now weighs a total of 78lbs



The rarely seen underside...


The brain and power center is all behind the seat. Back here is the computer, a pair of Sundown Audio amps, Sax100.4 on the passenger side and a Saz-1500D on the drivers side with the computer in the middle.



The guts behind the beauty panel

It'll be a month or so before I can show off again.
Here's my updated list though:
Clarion DRZ9255 with DSC920S satellite controller
Focal 165KRX3 in front. Mids and tweets in a-pillar, midbass in lower door.
Focal 165K2P in back, tweeter in c-pillar
JL Audio 10W7 sub front firing in center console 1.25 cu/ft sealed.
JL Audio 300/2, 300/4 and 1000/1 for power

It's gonna be NASTY !

I like those tweeters. Looks sick man

Eclipse AVN726E
MB quart qsd up front
MB quart rears
planet audio 400/4
3 l7 solo baric kickers
2250 planet audio

wow awesome looking setup...and can't wait to see yours Rich

OK Here it goes......

Dash: AVIC Z120BT w/ iPod
Doors: Alpine Type R Coaxial / Mmatts Tweeters on Pillars
Amps: Alpine MRV-F345 (highs and mids) Alpine MRD-M605 (subs)
Subs: JL Audio 6w0 (4)
Deadner: Stinger Expert Rodakill (100 ft^2) Stinger OverKill (30 ft^2) Stinger Carpet Pad (30 ft^2)
Wiring: Stinger 1/0 to dual 4 AWG, Stinger PRO3 6 Channel RCA's, Stinger HPM Series Twisted 14 AWG Speaker Wire to each Door.
Camera: Boyo Plate Cam w/ Night Vision

Pics:





Grill Cloth used so you can't see deadner and speaker through opening. Also this picture is with old Radio

Time to start posting up over here!

Pioneer AVH-P4100DVD
JL VR525-CSi Speaks
Sundown SAZ-1000D amp
3 Pioneer TS-SW2501S4 Subs

Still a work in progress, need to install my 4ch JL speaker amp...

jdc753 said:

Click to expand...

I like it, have you considered a narrow trim piece around it to bring it all together?

that screen is badass!!!

i have an alpine double din with JL door components with 300/4 on them.. and a JL 13w5 with a JL 500/1 pushing it.. it's not super loud but it's super clean

Wow, nice stuff in here. Not sure what I want to do with my truck yet. Most of my old stuff was ugly but really loud, phew glad I'm out of that phase.

Don't have pics yet but:

Kenwood h/u kdc 748
Massive rk's 6 in the door.
Massive tweets in the door in back and in the sail panel up front
2 MTX subs in a thunderform box under the seat in the rear
Clarion APX 400.2 for the subs
Kicker kx 600.4 for the speakers....soon to be a Massive D800.4

Well I haven't posted what I have in mind, I have had all the components sitting in my living room for a while. :doh: When my truck is back running this is what will happen. Dynomat and dynaliner or similar in doors, pillars, rear and perhaps floor. Pioneer Z110B with the Z120 upgrade, JL Audio ZR570 csi in doors, JL Audio HD600/4 powering the highs, 2 JL Audio HD750/1 for the bass. Ohh and those will be 2 JL Audio 12W7's in a cut through. XM radio and PAC steering wheel interface. I had something similar with different components prior, but this will be clean, loud and rattle your head! I read about Focal too late, or I would have bought those for my highs. This should do though. :thumbup: Pics will follow when it gets that far.

Erikclaw said:

Well I haven't posted what I have in mind, I have had all the components sitting in my living room for a while. :doh: When my truck is back running this is what will happen. Dynomat and dynaliner or similar in doors, pillars, rear and perhaps floor. Pioneer Z110B with the Z120 upgrade, JL Audio ZR570 csi in doors, JL Audio HD600/4 powering the highs, 2 JL Audio HD750/1 for the bass. Ohh and those will be 2 JL Audio 12W7's in a cut through. XM radio and PAC steering wheel interface. I had something similar with different components prior, but this will be clean, loud and rattle your head! I read about Focal too late, or I would have bought those for my highs. This should do though. :thumbup: Pics will follow when it gets that far.

Click to expand...

Do the floor and roof while your at it!!!!

I have seen and read your thread, is the roof worth it? The floor is a done deal. I would like the annoying rain noise that is right in my left ear to go away when raining. You went with raamat and ensolite correct? Ensolite just behind the door speakers, and ram everything else.

Erikclaw said:

I have seen and read your thread, is the roof worth it? The floor is a done deal. I would like the annoying rain noise that is right in my left ear to go away when raining. You went with raamat and ensolite correct? Ensolite just behind the door speakers, and ram everything else.

Click to expand...

Do the roof...hugh differance. I used FatMat and then used Raamaudio ensolite over it. Then I used a piece of the ensolite inside the door right behind the speakers

Thuglike said:

Do the roof...hugh differance. I used FatMat and then used Raamaudio ensolite over it. Then I used a piece of the ensolite inside the door right behind the speakers

Click to expand...

That makes sense since voices etc seem to bounce off roofs. I didn't think of putting ensolite anywhere but behind the speakers.

Thanks for the compliments guys, the screen was fun to install mostly a learning experience.


Some great setups all around too, definitely looking forward to the pics of the future projects

Erikclaw said:

That makes sense since voices etc seem to bounce off roofs. I didn't think of putting ensolite anywhere but behind the speakers.

Click to expand...

I would definitely do the roof. Mainly thinking the roof is a relatively thin metal vs the floor which is pretty solid. The roof is more similar to the outer door skins which are pretty prone to resonating due to the thin metals. I would imagine rain and wind noise would get cut down pretty big by doing the roof.

The ensolite/dynaliner like products are there to cut down air born noises (wind, tire, exhaust. sirens, etc.) by making a barrier for the sounds to pass through. While the dampener is there to cut down structural noises (speaker vibrations, drivetrain vibrations, rain drops, etc) by adding mass to the metal to reduce its reonant frequency. So the 2 are meant to work in unison to conquer all the noises from the vehicles and speakers motion to the outside noises.

Cool, thanks for the insight.

i've got an Alpine 103 HU with blue tooth and ipod control
alpine type R 6.5 fronts
alpine type S 5x7 rear
JL J2 500.1 monoblock amp
and a JL 10W3 running 500w @ 2 ohm
wanting to put type R 5.5's in the back
and amp the fronts
need to take some pics

I haven't posted pics yet but......

- 2 10" Kicker comps w/ grilles in separate sealed boxes.
- Kenwood KAC-7205 1000 watt amp.
- Kenwood KDC-BT848U headunit (Bluetooth, XM, HD, iPod, ect.)
- Kicker 6x8 coaxial speakers in back of cab.
Last thing to tidy up my system: Kicker 6 1/2's in the doors (they're still stock and suck)

It's a very tight fit behind the bench in the standard cab. It hits extremely hard inside, but surprisingly enough with no sound deadening stuff it's pretty quiet on the outside, which is a plus.