A "LOOK" at SPE's 6.7 PSD Stage 2 Heads

SPE

New member
Joined
Nov 28, 2011
Messages
622
Reaction score
0
Location
Carmichaels, PA (SW, PA)
We just finished up a set of heads and Figured some people would like to see what goes into are 6.7 stage 2 heads. The build begins with a set of good heads we Hand blend and remove valve shrouding after the seats then we abrasive flow machine (AFM) them and the intake manifold/ valve covers to match and transition. We then remove and install new hardened seats ( perf 2 angle cut), Skim surface the heads to an RA10 finish, 3 angle cut a new set of valves (rockwell tested) and cryo treat, Install new valve spring that are tailored to the customers needs.
CFM gains are substantial, normally theres a 32 to 36cfm gain on the intake and exhaust side.

These heads are not completely finished in some of these pics, There just some cool pics so that people can see what its about.

IMG_1088_zps19fbcc74.jpg


stg2springs_zps11e17d6b.jpg


IMG_1122_zpsdba6f71d.jpg


photo3_zps358d8e34.jpg

.................No Epoxy Just beautifully machined metal...................

IMG_1100_zpsf2757814.jpg


port_zpsa5fa96d5.png


IMG_1118_zpse5e48c6f.jpg


IMG_1120_zps8de49933.jpg


photo3_zps35fb0788.jpg
 

Latest posts

Members online

Top