Front coil spring question

One thing I've noticed about my truck is the front sits lower than every other F250 I've seen. I know the guy before me special ordered the truck, is there an option to get a lower front end? I don't really want to do a spacer, I'd like to find a little bit taller spring and swap them out. Any suggestions?

check the sticker on the drivers door pillar. the front axle pound rating will tell you what springs are in it. if it has 4800lb springs you can get some 6000 lb springs and it will lift it a bit.
there are a couple of dealers on here with good pricing.

Ok cool thank you for the quick response!

or go to an icon coil spring

TXGLASSMAN said:

or go to an icon coil spring

Click to expand...

How much would that lift the front?

depends what spring you order. There are 2", 2.5" or 3" i believe

i thought it was only 2.5", 4.5" and 7" coil springs but i could be wrong

I have a set of 6000 lb springs coming up for sale soon.

I have a set of 6000 springs laying around I would sell. I took them out to put in an Icon lift.

Sticker says I have 5200lb springs, would going to 6000 really make much difference?

not a whole pile. check the classifieds, there is a zone levelling kit with shocks for sale.

Icon has 2.5" springs for $424. I really want 2" taller springs, anyone know where I can get those for less than that?

Or would I be better off just getting a 2" leveling kit spacer for $99

From the reading I have done 6000 to 5200 should be about an inch to 1.5 difference. Can't get a for sure answer. Either way I would like to have your 5200 lb could when you figure out what you wanna do

Dzchey21 said:

From the reading I have done 6000 to 5200 should be about an inch to 1.5 difference. Can't get a for sure answer. Either way I would like to have your 5200 lb could when you figure out what you wanna do

Click to expand...

You want to do a straight up trade?

I would only problem for both of us is having an extra set of springs to use in the mean time for shipping. Let me see if I can gather a set up

Yea that would be a problem bc this truck is my only vehicle. Let me know what you figure out

Might have something lined out. Can you get the part number off the coil for me?