7.3 parts

02 7.3 motor. Includes heads, penlums, and all the internals. PMR rods. Has an oil pan but it is rusted through so it will need to be replaced. Ran good before it was pulled about a month ago - $300

gtp38 turbo. Very minimal shaft play, wheel is in good shape - $175

2 sets of SD up pipes. Includes collectors - $50 a piece

stock 4r100 tranny cooler - $40

turbo pedistal - $40

Oil cooler off of a van - $35

Flywheel and pressure plate w/clutch off of 95 psd - $100

Manual transfer case off of a 95 psd zf5. #1356 - $125

Or just take it all for $700

Will you sell the hpop ?

:whs:

Yeah. There is a small piece that broke off of the hpop where one of the bolts go through. It happened when I was taking it off the motor. It still works fine and the piece is getting welded back on right now. $150 for it once I get it back from the welder.

how many miles on the HPOP?

200k

single or dual mass flywheel?

Send the up-pipes and collectors to me at the shop (Swamp's) and I will get you a check cut.

Alright. I'll try to get them out in the next couple of days

How far are you from indy?

Im about 3.5 hours away from chicago, if that gives you any reference as to how far of a drive it would be