Go Back   PowerStrokeArmy > Power Strokes > 6.7 Tech

Thread Tools Display Modes
Old 03-24-2020, 05:34 PM
97cherokee 97cherokee is offline
Member's Gallery
Join Date: Jul 2015
Posts: 80
Default codes p0100

hey all I have a 2014 6.7 that is fully ******d and has been for some time. today I got code p0100 for the mass air flow sensor and another code for glue plug controller communications. i did some quick searching and found that often fuse 36 is blown due too shorts in the box sensor or its wiring. i checked fuse 36 and it's not blown, the box sensors are off of mine since its ******d, looked at the wiring and found that yes it is corroded so I unplugged the 3rd connector on the pcm and cleared the codes and rechecked and it still has both codes. I figure if the problem was down stream unplugging the emissions harness it would of eliminated the corrosion as being the issue or am i wrong?

where would yall suggest I start?

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -6. The time now is 01:37 AM.


Powered by vBulletin®
Copyright ©2000 - 2020, vBulletin Solutions, Inc.

Designed by Military Ltd