Horrible squeeling from front axle?

WILD_PHIL

New member
Joined
May 30, 2012
Messages
2,392
Reaction score
0
Location
East TX
Yesterday my truck started squeling. I figured I had a break hanging up. I went ahead and drove it home. Got up this morning and looked at it. I noticed metal shavings on my passenger wheel so I pulled the wheel. Rotor looked like it could be replaced so I pulled it to. Brake pads looked like chit. I put new pads and rotors on and bolted everything back up. It sounds just as bad now. I figured I'd check my hubs and they are nearly impossible to turn by hand. After driving it down my drive way and back it looks like my rotor is ate up again. Not that bad but doesn't look new after a quarter mile. I Googled it and found this video of a truck making the same sound.

https://youtu.be/tNo2L5_bMwI

E99 F350/zf6/guages/arp/comp/stellite/ billet wheel/ bellowed... Need more fuel and more air.
 
Last edited:

WILD_PHIL

New member
Joined
May 30, 2012
Messages
2,392
Reaction score
0
Location
East TX
Shredded 4x4 hub. It's the worse case I've ever seen.

E99 F350/zf6/guages/arp/comp/stellite/ billet wheel/ bellowed... Need more fuel and more air.
 

WILD_PHIL

New member
Joined
May 30, 2012
Messages
2,392
Reaction score
0
Location
East TX
Well all the bearings are shot

E99 F350/zf6/guages/arp/comp/stellite/ billet wheel/ bellowed... Need more fuel and more air.
 

co04cobra

Active member
Joined
May 21, 2011
Messages
3,003
Reaction score
10
Location
WV
If the inner spindle bearing is shot you'll probably need a stub shaft too.
 

WILD_PHIL

New member
Joined
May 30, 2012
Messages
2,392
Reaction score
0
Location
East TX
Stub shaft was actually good. Had to replace the bearing on it but that should take care of it.

E99 F350/zf6/guages/arp/comp/stellite/ billet wheel/ bellowed... Need more fuel and more air.
 

WILD_PHIL

New member
Joined
May 30, 2012
Messages
2,392
Reaction score
0
Location
East TX
Until I can overhaul the front end.

E99 F350/zf6/guages/arp/comp/stellite/ billet wheel/ bellowed... Need more fuel and more air.
 

WILD_PHIL

New member
Joined
May 30, 2012
Messages
2,392
Reaction score
0
Location
East TX
55e0bb375a46380142e3a972ca6470af.jpg


I'm pretty sure this stub shaft is shot. Agreed?

E99 F350/zf6/guages/arp/comp/stellite/ billet wheel/ bellowed... Need more fuel and more air.
 

WILD_PHIL

New member
Joined
May 30, 2012
Messages
2,392
Reaction score
0
Location
East TX
Any ideas on the differences between the pre 3-99 and post 3-99 hubs? I can get 2 of the post 3-99 hubs for 115. A pre 99 is 90 bucks for 1.

E99 F350/zf6/guages/arp/comp/stellite/ billet wheel/ bellowed... Need more fuel and more air.
 

co04cobra

Active member
Joined
May 21, 2011
Messages
3,003
Reaction score
10
Location
WV
No difference in any of the hubs. And that stub shaft looks trashed?
 

Bluke

Member
Joined
May 27, 2014
Messages
219
Reaction score
0
Location
Colorado
The rotor hat is different on the e99. You can put l99 hubs on it but you need rotors too. I can't remember if you need anything else. Also I recommend timkin hubs. The cheapo from the parts house will go out pretty quick
 

WILD_PHIL

New member
Joined
May 30, 2012
Messages
2,392
Reaction score
0
Location
East TX
Any ideas why someone would disconnect the ABS wires?

E99 F350/zf6/guages/arp/comp/stellite/ billet wheel/ bellowed... Need more fuel and more air.
 

pdumont01

New member
Joined
Jun 21, 2015
Messages
383
Reaction score
0
Location
CT
If the sensor ring in the hub is going bad it can cause false activation and the brakes won't work well, unhook sensor abs is deactivated and no more brake problem

Sent from my Nexus 6 using Tapatalk
 

co04cobra

Active member
Joined
May 21, 2011
Messages
3,003
Reaction score
10
Location
WV
Any ideas on the differences between the pre 3-99 and post 3-99 hubs? I can get 2 of the post 3-99 hubs for 115. A pre 99 is 90 bucks for 1.

E99 F350/zf6/guages/arp/comp/stellite/ billet wheel/ bellowed... Need more fuel and more air.



Did you mean 4x4 lock hub or bearing? Didn't see your post below the picture before. But that stub is trashed.
 

WILD_PHIL

New member
Joined
May 30, 2012
Messages
2,392
Reaction score
0
Location
East TX
I meant the hub bearing. I replaced the locking hubs in January

E99 F350/zf6/guages/arp/comp/stellite/ billet wheel/ bellowed... Need more fuel and more air.
 

Swsignal5

New member
Joined
Dec 9, 2014
Messages
503
Reaction score
0
Any ideas on the differences between the pre 3-99 and post 3-99 hubs? I can get 2 of the post 3-99 hubs for 115. A pre 99 is 90 bucks for 1.

E99 F350/zf6/guages/arp/comp/stellite/ billet wheel/ bellowed... Need more fuel and more air.

Shredded 4x4 hub. It's the worse case I've ever seen.

E99 F350/zf6/guages/arp/comp/stellite/ billet wheel/ bellowed... Need more fuel and more air.

Well all the bearings are shot

E99 F350/zf6/guages/arp/comp/stellite/ billet wheel/ bellowed... Need more fuel and more air.
I have a late model hub if u need one. Brand new oem Ford. Still in the box

Sent from my QMV7A using Tapatalk
 

WILD_PHIL

New member
Joined
May 30, 2012
Messages
2,392
Reaction score
0
Location
East TX
I picked up 2 of them for 115. I'm just going to do both sides. I need a pair of stub axles if you got em.

E99 F350/zf6/guages/arp/comp/stellite/ billet wheel/ bellowed... Need more fuel and more air.
 

WILD_PHIL

New member
Joined
May 30, 2012
Messages
2,392
Reaction score
0
Location
East TX
Question. Do these trucks take the same u joints in the outter stub axle that they do on the rest of the truck?

E99 F350/zf6/guages/arp/comp/stellite/ billet wheel/ bellowed... Need more fuel and more air.
 

co04cobra

Active member
Joined
May 21, 2011
Messages
3,003
Reaction score
10
Location
WV
Question. Do these trucks take the same u joints in the outter stub axle that they do on the rest of the truck?

E99 F350/zf6/guages/arp/comp/stellite/ billet wheel/ bellowed... Need more fuel and more air.


No. Cant remember the #s off the top of my head but they are different.

Front axle joints use inside C-clips while rear u joints use outside snap rings.

Few of the differences off the top of my head.
 

WILD_PHIL

New member
Joined
May 30, 2012
Messages
2,392
Reaction score
0
Location
East TX
Good call. I realized that right after I posted. I've searched for outter stub axle u joint and can't find chit.

E99 F350/zf6/guages/arp/comp/stellite/ billet wheel/ bellowed... Need more fuel and more air.
 
Top