F350 blocks on F250

Probably covered time after time, but I can't seem to find my answer.

I have a 2016 F250 and purchased some 2008 F350 blocks. It's dark out now so I can't really see if my current blocks are tapered or not and it doesn't really look like the F350 blocks are tapered.

I have a 1 piece driveline

Are my chances slim for working?


Sent from my iPhone using Tapatalk

You will be good. Your 2016 blocks are not tapered.

onyx said:

You will be good. Your 2016 blocks are not tapered.

Click to expand...

Again, thanks for the information!


Sent from my iPhone using Tapatalk

Does anyone make an aftermarket block that is the same height as the F350 stock block?

treatcg said:

Does anyone make an aftermarket block that is the same height as the F350 stock block?

Click to expand...

https://www.amazon.com/ReadyLift-66-2014-Rear-Block-Ford/dp/B003WRA90O

Or you can do ouo traction blocks

I put the 3.625" OUO traction block on mine and like said above it's the same size as the F-350 block. Very well built product.

Swampfox said:

I put the 3.625" OUO traction block on mine and like said above it's the same size as the F-350 block. Very well built product.

Click to expand...

Hit up pmf . Trevor can make you any size block/taper you want


Sent from my iPhone using Tapatalk

350 blocks from the shortbed are tapered and not tapered on the longbed with carrier bearings. It does make a difference, I bought 4" blocks for my 350 with overload springs and the blocks have a slight taper so I have driveline vibration.