Injector Modification Identification

Mdub707

Active member
Joined
May 18, 2011
Messages
5,079
Reaction score
0
Location
Mohawk NY
Not really, only good way is to pull it apart and take some measurements. I know some shops engraved the injector body or something, but I don't think any of the shops worth taking injectors to would do this, but I could be wrong.
 

KCTurbos

Active member
Joined
Jan 18, 2014
Messages
1,295
Reaction score
12
^^^^ what he said


Also sometime the nozzle size is printed low enough that you can read
 

swinky

New member
Joined
Apr 25, 2013
Messages
8,350
Reaction score
0
Location
Eastern, Nc
Do any of you guys know if there is a way to visually check to see if an injector has been modified or not?
How's it going buddy?

Personally I'd just send them off and have them flowed and gone over while they're out.
 

03cody

Member
Joined
Jul 22, 2013
Messages
243
Reaction score
0
Location
Bethany Illinois
I'm pretty good lol. Just gearing up for my "build".

That's probably what I'm gonna do though. I feel like it's the best option


Sent from my iPhone using Tapatalk
 

Mdub707

Active member
Joined
May 18, 2011
Messages
5,079
Reaction score
0
Location
Mohawk NY
Holders Diesel can go through them for you and tell you what is done as well as flow them. MPD can do the same, both are good shops and at the top of my very short list of trusted places to send injectors for a 6.0.
 

03cody

Member
Joined
Jul 22, 2013
Messages
243
Reaction score
0
Location
Bethany Illinois
Holders Diesel can go through them for you and tell you what is done as well as flow them. MPD can do the same, both are good shops and at the top of my very short list of trusted places to send injectors for a 6.0.


I talked to Rykan today and I'm gonna go ahead and send them there. I talked to Jared at RCD too but holders was a bit cheaper and I've heard nothing but good things about his work. Not to say I've heard bad things about RCD because I think they are a great shop.

Anyway, holders is gonna check them, flow them, and re o-ring them.

I was thinking about maybe doing some smaller nozzles. Like maybe 30s instead of 70s. I do still tow.


Sent from my iPhone using Tapatalk
 

Mdub707

Active member
Joined
May 18, 2011
Messages
5,079
Reaction score
0
Location
Mohawk NY
Don't quote me, but I believe Holders is around $40 per to check them over. I'm sure parts are extra on top of that. I think a set of nozzles will run you around $400 maybe.
 

03cody

Member
Joined
Jul 22, 2013
Messages
243
Reaction score
0
Location
Bethany Illinois
Don't quote me, but I believe Holders is around $40 per to check them over. I'm sure parts are extra on top of that. I think a set of nozzles will run you around $400 maybe.


Yea you're pretty close. Rykan told me 35 dollars per injector. I haven't actually talked to him about nozzles yet though. If it is around 400. I'm most definitely gonna get some.


Sent from my iPhone using Tapatalk
 
Top