No start after cup and injector install

dogdog130

New member
Joined
Mar 26, 2015
Messages
18
Reaction score
0
just replaced my cups becouse of bad leak. well replaced all cups and injector from a rolled truck the truck ran when pulled. well installed went to start and have tried for 2 days on and off still not start did buzz test and passed , checked oil reserve and was full any ideas. when i first tried to start it acted like it was hydrolocked and then hit it again and been turning fine

https://youtu.be/WCiDfm9i9rQ

Sent from my SM-G930V using Tapatalk
 

johngaddis

New member
Joined
Oct 13, 2016
Messages
5
Reaction score
0
Yeah liquid doesn't compress very well. Could have jumped time maybe.

Sent from my 0PJA2 using Tapatalk
 

Arisley

Moderator
Joined
May 18, 2011
Messages
9,378
Reaction score
25
Location
Arlington, Texas
If Hydrolock caused it to jump time, you have worse problems than you can even think about. Hydrolock will bend a rod.
 

ghohouston

Active member
Joined
Dec 2, 2012
Messages
4,023
Reaction score
15
Location
Lewisville,Texas
Did you prime the fuel system, and lube the injector o rings when you re installed the injectors? Engine oil level? Uvch's properly together? I have literally never seen someone bend anything on a motor from turning it over while hydrolocked. Is it smart? Hell no, but i have seen it done numerous times with no problems. Could it be cranking too slow?
 

johngaddis

New member
Joined
Oct 13, 2016
Messages
5
Reaction score
0
Also, ohm the injector and make sure, A: it has current B: it is the correct current in range.

Sent from my 0PJA2 using Tapatalk
 

Latest posts

Members online

Top