Light switch???

CSIPSD

New member
Joined
May 18, 2011
Messages
5,284
Reaction score
1
Location
Bend, OR
Not getting any marker lights to the truck or trailer... Headlights work, brake and turn signals work..

Checked every fuse...

Switch maybe? I need to keep moving so I can make it back to Washington without running lights...
 

PsdPullerJr

Member
Joined
May 17, 2013
Messages
515
Reaction score
0
Location
Western PA
No markers front and rear? I lost my rear tails and it was a wire corroded off back at the bumper at one of the connectors that hook the truck to the bed.
 

CSIPSD

New member
Joined
May 18, 2011
Messages
5,284
Reaction score
1
Location
Bend, OR
Why would the headlights work but not the marker lights? Got to be the switch?

Do the marker lights run thru the gem module?
 

Dave

New member
Joined
May 18, 2011
Messages
1,555
Reaction score
0
Thats a switch if its on both the truck and trailer. Unless the fuses are blown
 

TyCorr

New member
Joined
Jun 23, 2011
Messages
15,461
Reaction score
0
Why would the headlights work but not the marker lights? Got to be the switch?

Do the marker lights run thru the gem module?

Those light circuits are wired seperately coming out of the switch. I shorted out a switch once and it was doing exactly what you are describing. The question is, why did yours go as I had to probe wires to cause it.

To amswer the gem question. No I believe they go into the dr side kick panel and then to the lights on the chassis.
 

CSIPSD

New member
Joined
May 18, 2011
Messages
5,284
Reaction score
1
Location
Bend, OR
Picking up a new switch at Ford shortly... $190... FOOKing expensive test. Hope it works!
 

CSIPSD

New member
Joined
May 18, 2011
Messages
5,284
Reaction score
1
Location
Bend, OR
Where is the "park lamp relay"...

10603466_340667166108358_8991808886760033664_n.jpg
 

Arisley

Moderator
Joined
May 18, 2011
Messages
9,379
Reaction score
25
Location
Arlington, Texas
Found it:

http://www.ford-trucks.com/forums/796193-wiring-and-relay-for-4h.html

The transfer case clutch relay is located in a RPO relay block. This block is behind the dash on the passenger side, up high near the base of the windshield.

The transfer case shift relay module is also behind the dash up high, but more over in the center of the dash up high behind the radio area.

The GEM module is a fairly large box with three plugs going to it, and is mounted on the driver's side under the dash, close to the driver's side kick panel area.
__________________
 
Last edited:

Members online

No members online now.
Top