znunez72
New member
Figured i might as well share my build with everyone.
Truck is a 2010 F250 KR with Quad Captains. The factory audio is terrible. Finally got tired of it and planned out an in-depth SQ build. I listen to all genres of music so clarity and little to no distortion is wanted. Will also be installing a pure sine wave inverter while the truck is torn apart when the time comes. Sync and steering wheel control will be retained using the Maestro RR unit.
Audio Components:
Alpine X008U DD Nav
Sirius Tuner
Alpine H800 DSP
Alpine Rux controller
Maestro RR with ford 01 harness.
HAT l6SE for mids in doors
HAT L1 Pro R2 tweeters in A pillar pods.
8W7s in each center console.
3-JL HD600/4 amps mids and tweeters.
2 JL HD750/1 amps for subs
SMD Mono RCA and splitters
KNU Fleks 1/0 Tinned OFC power wire.
KNU Karma 10 ga and 14 ga speaker wire.
SDS CLD tiles, CCF and MLV.
ToolMakerz Custom Fused Power and Ground distribution blocks ( 2 1/0 in-3 1/0 and 3 4ga out)
Clear shrink sleeves and a label maker
Many feet of techflex
XS D6500 Batteries
Front stage will be ran active. Rear stage will be left alone for a couple months while I get the front squared away.
The Mids will be ran on 300w a piece. One 600/4 bridged will be used.
Tweeters will receive 150W a piece from a 600/4.
Gains will be adjusted using SMD meters. The Goal is ZERO clipping.
Still gathering a couple items then the teardown will begin.
Will update with pics once it comes time for the install.
Any install tips?
Truck is a 2010 F250 KR with Quad Captains. The factory audio is terrible. Finally got tired of it and planned out an in-depth SQ build. I listen to all genres of music so clarity and little to no distortion is wanted. Will also be installing a pure sine wave inverter while the truck is torn apart when the time comes. Sync and steering wheel control will be retained using the Maestro RR unit.
Audio Components:
Alpine X008U DD Nav
Sirius Tuner
Alpine H800 DSP
Alpine Rux controller
Maestro RR with ford 01 harness.
HAT l6SE for mids in doors
HAT L1 Pro R2 tweeters in A pillar pods.
8W7s in each center console.
3-JL HD600/4 amps mids and tweeters.
2 JL HD750/1 amps for subs
SMD Mono RCA and splitters
KNU Fleks 1/0 Tinned OFC power wire.
KNU Karma 10 ga and 14 ga speaker wire.
SDS CLD tiles, CCF and MLV.
ToolMakerz Custom Fused Power and Ground distribution blocks ( 2 1/0 in-3 1/0 and 3 4ga out)
Clear shrink sleeves and a label maker
Many feet of techflex
XS D6500 Batteries
Front stage will be ran active. Rear stage will be left alone for a couple months while I get the front squared away.
The Mids will be ran on 300w a piece. One 600/4 bridged will be used.
Tweeters will receive 150W a piece from a 600/4.
Gains will be adjusted using SMD meters. The Goal is ZERO clipping.
Still gathering a couple items then the teardown will begin.
Will update with pics once it comes time for the install.
Any install tips?
Last edited: