Obd2 splitter

Has anyone ever used an obd2 splitter? I was thinking of using one so I could run more than one digital gauge setups, I have my livewire and I may have modified my dash to make it fit, and I want something with a little better options for things to monitor


Sent from in a ditch up side down and on fire with the wheels still spinning

I was think edge insight cts, or a scangauge


Sent from in a ditch up side down and on fire with the wheels still spinning

they typically conflict each other since they are both reading sending pid request

you can try it because the cable is cheap

Yeah the cable is cheap, but the second monitor is not


Sent from in a ditch up side down and on fire with the wheels still spinning

if you don't have the second monitor I wouldn't try it

I use it for My Insight and either x3 or A/E and one will always overide the other

Yeah I'm just gonna use gauges, add an EOT, fuel pressure, another pyro, and some other ones


Sent from in a ditch up side down and on fire with the wheels still spinning

I use a cts and have a standalone digital EGT and Fuel PSI

That would be awesome, I use the livewire for EGT, volts, injection timing, trans temp, and coolant temp, I just want to monitor a few more things, I am a gauge nerd, I want to know everything that is going on


Sent from in a ditch up side down and on fire with the wheels still spinning

I have a splitter and my dash daq doesn't like it but the mini maxx works fine

Yeah looks like I'll add more gauges, many more


Sent from in a ditch up side down and on fire with the wheels still spinning

My OBD splitter works fine 99% of the time. If one of the Dash Daqs act up I just restart it and all is good.