rockinhorse
New member
- Joined
- May 1, 2019
- Messages
- 5
- Reaction score
- 0
Hi all, Newbie here.
I am in process of rebuilding my 4r100 and cannot get the output shaft snap ring to go on. I cannot even see the grove where it goes after the rear planetary ring gear and bearing are installed. I am positive that the output shaft is in all the way. Few taps on a block of wood on the floor insured that. I have been using the ATSG manual for the rebuild, following it step by step.
Any ideas or tips to get this snap ring in?
It's a 1999 F350 Super Duty.
Thanks
I am in process of rebuilding my 4r100 and cannot get the output shaft snap ring to go on. I cannot even see the grove where it goes after the rear planetary ring gear and bearing are installed. I am positive that the output shaft is in all the way. Few taps on a block of wood on the floor insured that. I have been using the ATSG manual for the rebuild, following it step by step.
Any ideas or tips to get this snap ring in?
It's a 1999 F350 Super Duty.
Thanks