What did you use for intercooler brackets

freddie

Member
Joined
May 18, 2011
Messages
301
Reaction score
0
Location
Ohio
What materials did you use for your upper and lower IC brackets?
I have seen a lot of pics where guys used angle for the lower, and flat stock for the upper.

What size and thicknesses? Going to try to pick some up and knock out my IC mounting this weekend

.
 
Joined
Jul 8, 2011
Messages
569
Reaction score
4
Location
Central CA Foothills
It takes 1 1/4 square tube about .120 wall or heavier for the lower horizontal bar. 2” angle minimum 3/16 for the bracket to weld to that and bolt to the core support. 3/16 x 2 1/2 for the upper tabs. I had more problems finding the lower and upper rubber mounts. The lower ones that slip into the pocket in the IC and over the 1 1/4 tube were available from Ford. The uppers are discontinued but 2nd gen Dodge ones fit. I think Freightliner M2 ac condenser mounts will work too.
 

danielzink

Member
Joined
Jan 10, 2012
Messages
42
Reaction score
0
Couple pics for ideas...
 

Attachments

  • P1010011a.JPG
    P1010011a.JPG
    684.8 KB · Views: 87
  • P1010012a.JPG
    P1010012a.JPG
    703.9 KB · Views: 82
  • dscn8075.jpg
    dscn8075.jpg
    379.1 KB · Views: 88
  • dscn8076.jpg
    dscn8076.jpg
    383.2 KB · Views: 82
  • dscn8080.jpg
    dscn8080.jpg
    336.6 KB · Views: 80
Last edited:

Latest posts

Members online

No members online now.
Top