Getting Rims/Tires + Keeping Stock Hieght

08IH6.4 · Mar 22, 2015

Is it possible to fit 20x10 (-25 offset) Ultra Wheel Crushers with 35x12.5x20 MT BAJA MTZ tires?? I will install a 1.5" levelling kit if need, but I must fit into my garage. I will be taking the truck off road lots so I don't want any rubbing, but have lots of zip ties.

Lipka101 · Mar 23, 2015

35's will be too big with that wide of wheel and offset. Probably will rub with a leveling kit. Go with 33's. They are cheaper and will look better.

DWhite · Mar 23, 2015

I have 35 12.50 20s on monster xd wheels with a -12 offset without rubbing and I'm at stock height. I think with that much offset it might run on the inner fender when turning but I bet you could trim or pull it back if you wanted to. I would probably run 1 Or 2 inch leveling kit if you can. But you can always try it and see if it fits then raise it some after.

01pwrstkr · Mar 23, 2015

My truck is bone stock height. 20x10 RBPs -25 offset. 325/60/20 Nitto Terra Grapplers. According to the calculator that's 35.4x12.8. They rub on the inner fender a little bit (it's pulled back pretty far with zip ties). And it also rubbed on the bottom of the fender on the little metal lip that hangs down. I cut a little bit of that metal lip off and folded it back some and it doesn't hit it anymore. And you can't tell it's been "modified" unless you are looking for it. Here's a couple pics.

"3 can keep a secret if 2 are dead"

08IH6.4 · Mar 23, 2015

Thank you! God, damn that's a nice 6.4!!! Cant wait to get them on!!! Looks amazing.

01pwrstkr · Mar 23, 2015

08IH6.4 said:
Thank you! God, damn that's a nice 6.4!!! Cant wait to get them on!!! Looks amazing.

Lol thanks bro! Post some pics when you get them on!

"3 can keep a secret if 2 are dead"

sootie · Mar 25, 2015

08IH6.4 said:
Is it possible to fit 20x10 (-25 offset) Ultra Wheel Crushers with 35x12.5x20 MT BAJA MTZ tires?? I will install a 1.5" levelling kit if need, but I must fit into my garage. I will be taking the truck off road lots so I don't want any rubbing, but have lots of zip ties.

they will only require minor trimming to fit and the inner fenders pulled back. anything other than street driving they will hit the body hard.

eiorg9 · Apr 2, 2015

it will work. I am running 35x12.50x20 and only have installed a leveling kit. When i back up hard left i get a very little rubbing but i cut the fender a little and now its perfect. i Also have a pretty substantial offset as well.

08sixfour12 · Apr 27, 2015

DWhite said:
I have 35 12.50 20s on monster xd wheels with a -12 offset without rubbing and I'm at stock height. I think with that much offset it might run on the inner fender when turning but I bet you could trim or pull it back if you wanted to. I would probably run 1 Or 2 inch leveling kit if you can. But you can always try it and see if it fits then raise it some after.

DWhite, Can you post a pic of your trucks rims/ tires, I'd like to see a -12 offset.

thanks