78f100
Active member
What is the max piston to wall clearance you guys would run on a 6.4? My old block definatly needs boring but I bought a spare motor that measures out good except one cly # 8. It had a blown egr cooler and bent rod in that hole. I think I can get by with honing and should end up with close to .06 piston to wall clearance.
The manual I have says factory is .018 to .037 seems kinda tight to me, but this is my first diesel engine bottom end.
The manual I have says factory is .018 to .037 seems kinda tight to me, but this is my first diesel engine bottom end.
Last edited: