VGT Solenoid Connector

superduty4x4

Member
Joined
May 19, 2011
Messages
998
Reaction score
0
Location
Newport, WA
I broke one of the locking tabs off the VGT connector this weekend, looking to change over from the style with the 2 plastic tabs to the wire bail style connector. Does anyone know if you can or how to remove the wires from the connector so that I can just replace the connector itself and not have to cut/splice wiring?
 

Strokersace

Well-known member
Joined
May 20, 2011
Messages
4,878
Reaction score
36
Location
Towanda, KS
In all seriousness, the pins are held in via clips on the plastic. Should be able to use a pick or something to unclip them and pull them out the back.
 

superduty4x4

Member
Joined
May 19, 2011
Messages
998
Reaction score
0
Location
Newport, WA
In all seriousness, the pins are held in via clips on the plastic. Should be able to use a pick or something to unclip them and pull them out the back.
I was messing with an old 7.3 injector harness I have, and it looks to me like I'd have to release a retaining tab, slide the pin out the front, bend 2 little ears down, then pull it out the back. I'm just nervous to try and pull that off without f*cking up the pin so I was hoping someone else had tried it and had some pointers.
 

Latest posts

Members online

No members online now.
Top