Bullseye s480

Bought this had some big plans, now going a different route, so i dont need this.. new, t6 1.32 96mm turbine $1100 shipped

Damn no compounds?

Nah, don't want to pull a MadDiesel and throw a rod :doh:

Daaaaaam. billet rods are only 2500k away plus tear down plus balance plus plus plus a couple more g's. Cmon playa!

$1050 shipped

Hmmm, I wonder if this would work with my GT4294r with 1.01 exhaust housing.
Wastegated of course.

For 250/100's im sure it will supply more than enough air. If your single spools decent as it is now im sure it wont have an issue lighting this.

My 4294r spools just like the 38r did and I do have plans for bigger injectors when the built motor goes in.

Every turbo and injector combo I've run in the past would pull below 1800 RPM's a bit but right at 1800 and above, it was game on, dial a boost with the throttle.
I dont want to run a compound combo that moves that 1800 RPM point up any higher.
I would really like to get that dial a boost point to come down a bit with a compound setup if I could.
Can you pm me all the specs, compressor inducer and exducer sizing and same for the tubine side?
I only want to build the plumbing setup one time.
Thanks

Compressor 80/115.5
Turbine 10 blade 96/88
5" v-band turbine outlet

Bump, make offers

Use the 480 as a single on your new build

On the beamer? LOL

Bump

Christmas bump $950

shhooollldd