Recent content by Tanker3278

Turns out the 03 didn't have the jumper harness. Had to cut the pigtails off. My 05 does have the jumpers. Since my 05 pigtails are already chewed up, I'm going to order new replacements and install them. Will clean up and solder/shrink tube the two old pairs into a pair of functioning backups...

Good to know! Thanks for the pointers! Headed back to the junkyard this morning! Sent from my LM-Q620 using Tapatalk

After 5 years I finally got tired of looking at my mangled gray bumper on my 05 F350. Bought the truck with it that way. Was a fleet truck and had the old sealed beam bulbs. Junkyard in southern Indiana didn't have any 05-07s. Had newer stuff (08+) that would require converting the whole front...

If you have an OBD2 reader that will show live data then check the reading on some of the other sensors. I identified my cluster had a problem when the fuel guage went from 3/4 to empty with a buzzer while driving. OBD2 reader showed the computer reading the fuel tank at 75% while the cluster...

Anyone know where the signal runs through the PCB in the instrument cluster? I can take more pictures if needed. I've already changed the alternator, charged the batteries, checked continuity & fuses on PDB and under the dash. Still only charging at 12.5v. Sent from my LM-Q620 using Tapatalk

Do you still have that ZF6? Sent from my LM-Q620 using Tapatalk

Local 6.0L guru told me my injectors will need rebuilding or replacing in the near future. (no BS, he's an old white-haired mechanic who's about to retire) Bought a set out of a junkyard for cores. If I buy the parts & rebuild them myself, do the need to be run on a flow bench to be...

Bismic & ncollins, thank you! Sent from my VS988 using Tapatalk

I'm about half retarded. Replaced the MAP & line to the manifold. Didn't fix the problem. Looked at the baro sensor. Was working and reading 29.60. I figured if the baro sensor had failed the computer would have defaulted to 29.92 (standard sea level pressure). Still not getting a signal. So...

What is the name of this cover piece for the wiring harness above the turbo? I want to replace mine but don't know its name to search for it...? I got mine zip-tied in place right now... http://powerstrokearmy.com/photopost/data/500/medium/0823191949.jpg

Decided to replace the MAP sensor. (Per GHOHouston's advice) Pulled the hose off with the old sensor. Was split down by the clamp. Thanks GHOHouston! http://powerstrokearmy.com/photopost/data/500/medium/0823191934.jpg Was going to trim off the end, but the end crumbled when I started cutting...

Had a eurika moment when playing with FORScan this afternoon. I don't have a fuel pressure guage, but I think I'll have to get one. I finally figured out where the error codes are in those menus. http://powerstrokearmy.com/photopost/data/500/medium/Capture_2019-08-22-17-57-03.png...