Search results

I bought this truck with this issue. The gem is reading the door ajar switches backwards. Doors closed the ajar light is on. Open the light goes off. I've swapped switches with good ones and same issue. I cut and flipped the positive and negative wires on plug and still same issue. That seems to...

Located in Cleveland. Will travel.

It's a 1996 motor and trans. When it came out of the donor truck it drove and shifted fine. Now the speedo doesn't work, when you put it in hear it high idles. Especially reverse, it wants to fly. It has horrible hard shifts and when you get out of throttle and back in there is a delay and it...

Can a injector cup on a 2004 6.0 be replaced cab on?

Truck is from ga and I'm the second owner. Absolutely no rust or surface rust. 112,000 miles Mods Ranch hand front and rear bumpers Harley headlights Arp studs Egr delete Blue spring Airdog 150 MPD 165/100% injectors built from new with 3,500 miles on them New starter and HPOP 08 oem mirrors...

I am looking to build a 6.4 for strictly drag racing. What I am looking for is a wrecked 6.4. I have a complete shop and have an abundance of body parts but would like to start with a good engine as a base. I am a young diesel tech and have a decent amount of knowledge about the mechanic side of...

Preferably a scsb but up for anything right now. I am looking for a truck to build for strictly drag racing. This will be my first build like this. Any opinions would be helpful.

I have a cyl 8 failing a contribution test. New injector and wiring harness. What else could cause it. Also, cyl 3 has a P1273 high to low side open. New wiring harness also and I swapped the solenoid with another injector. Code did not move. Truck has slight miss and long crank

Can you reuse the fuel lines going from high pressure fuel rail to injector? I'm trying to swap injectors to make sure it's bad and not the harness. Just don't want to end up buying 1 injector and 2 fuel lines

I already posted in the WTB section but there wasn't one vendor that hit me up. 99 7.3 extended cab. I need 4 in turbo back no muffler and a ts 6 pos. Need it ASAP. 912-614-2223

Some one deleted cat and Dpf but welded the probes back into the straight pipe. There was no programmer in the truck. Idk if it's possible it's on stock tune and why someone would put those sensors back in. It's got white smoke at idle that smells like raw diesel. Seems to idle fine for a while...

Need prices ASAP 912-614-2223

Will travel and have cash

Looking for a new or used sct for a 6.0. Prices with custom tunes and without

I'm swapping a 95 7.3 into a 92 f250 that had the 5.8. From what I can tell the front crossmember is completely different. Anyone gave a picture of one for comparison? Or one I can buy!

Putting the motor in a truck that had a 5.8.

Loss of low end power and it looks like a damn coal train 24-7. The slightest acceleration and it blows a good amount of black smoke.

I know they are here but don't seem to be posting too much in the wtb section. I'm looking for 4in turbo back for a 07 f250 ccsb

Need it today 912-614-2223

This is my first time really toying with a 7.3. We're putting it in a 93 cclb. It had a 5.8. The motor is out and just looking for some preventative mods and small performance but nothing huge. Does everyone run a different downpipe because I can't see how the flat one helps the motor at all?