Search results

Does anyone know by chance the torque sequence and the crc lube part number for extreme studs?

Looking to sell a swamps built s475 clipped to a 2.6. Billet compressor wheel, 83mm turbine with t4 .9 housing. Turbo is new with 0 miles. Purchased it for a pulling truck and ended up going to a 2.6x3.35 before the s475 was ever installed. $1300 shipped located near Somerset Pa.

On my way back to work from lunch my trans started slipping so I hooked up the ids and checked codes. After I pulled codes, my truck would just crank and not start. Icp was about 600psi, has rpm and sync, ficm is a 58v for swamps with a php tune but voltage was 47 and 9. Did an injector buzz...

I swapped my Barder stage 3 out for a s366 last night. After driving the truck today I don't know how people daily a non vgt. In my opinion it was a huge step backwards. The truck rolls tons of smoke unless I'm above 2700 rpm, coasting down hill, or barely on the throttle on a flat. On hills and...

Ive had my truck for about 10k miles so far. Before I ever drove it I installed arp studs with factory gaskets and machined heads, egr delete, new oem oil cooler, rr fuel with low pressure pump feeding stock. Since then I've installed a ported intake, 68mm pmax, 190/100 injectors and rebuilt...

My truck had a bad flare between 3-5 shifts. Pulled trans apart found direct drive clutches smoked and hot spots on overdrive. Installed suncoast and transgo kits with new pistons and seals from ford. After about 300 miles on the new trans the flare would randomly come and go. Yesterday it...

I had a core 04 5r110 built with a suncoast and a transgo kit that I was going to swap into my truck because mine flares up from time to time. My trans guys called me and said a guy with a plow truck (who's in a bind) said he would buy it from me and give me an 08 core to build. The trans guy...