Search results

Finally. Ordering. Thank you! Sent from my iPhone using Tapatalk

Sorry forgot to mention most likely Turbo Shaft Seal. Sent from my iPhone using Tapatalk

Injectors won’t be blue that’s oil-ish smoke. Check compression for ring clearance otherwise check heads for valve stem seals. Sent from my iPhone using Tapatalk

Just checked The boxes are up to 07-30-2007 And then after 08-01-2007 So by what you said you are 02-2007 So you can not upgrade your box unless you get a new column. Or replace the end. You would need to be 08/07 Sent from my iPhone using Tapatalku

2011-2016 not sure about 17 Just make sure your build date is after 08/08 or else you will not have the same type spline for the steering column. Any 11-16 will work and is updated with a tighter recirc ball. 11-16 will be a direct bolt in with no drilling which I would use as you could harm...

UPDATE: pin 2 on the encoder motor was corroded, yellow with white tracer, spliced in spare connector, all was good. Thanks guys! Sent from my iPhone using Tapatalk

Okay yes I understand that. Pretty sure his hubs are unlocked. But even so if they were locked I don’t think it would keep the engine from shifting like its in a Low Gear. Sent from my iPhone using Tapatalk

And can you explain more about the hubs being unlocked and tcase spinning the front shaft? Not clear to me. Thank you. Sent from my iPhone using Tapatalk

Electronic, And if the motor was bound up, that would cause the light not to show up? I read that there is a connector 2 wire I believe that grounds either for the high and low lights. Can anyone with a diagram confirm? I’ll try grounding both, I’m on Holidays for 2 months. And I won’t have...

Have you looked at the transmission strategies, make sure the tune is the same trans strategy? There is tqje and tqjf if you load the wrong tune you’ll have reverse only no forward gears. Sent from my iPhone using Tapatalk

Long story short, I’m a mechanic, I would like actual techs or professionals only respond. Thank you. Did up pipes and a tranny on a 6.4 Tranny is a #50 casting from a 6.0, Replaced the TC with a 6.4 TC Cut and spliced in a new TCM connector with the 10mm bolt going through it to the...

Haha I had just painted my caps at the shop Sent from my iPhone using Tapatalk

But for real where did they come from? Sent from my iPhone using Tapatalk

Nono can’t see that at 100 miles an hour. Lol Sent from my iPhone using Tapatalk

I see you got a Harley as well. Welcome haha. I sure think those headlights would look fancy in mine. Sent from my iPhone using Tapatalk

Those are kind of cool. Where did you get those? What are they rated for bulb wise LED or HID? Are they DOT approved? I could be interested in a set. Sent from my iPhone using Tapatalk

Me as well Sent from my iPhone using Tapatalk

For a 6.4 powerstroke Comes with MAF Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

How much to make another one for my harley truck. Lol shipped to Canada. Sent from my iPhone using Tapatalk