Search results

  1. R

    blown up e40d?

    hey so my e40d shifts kind of funny. its been running like that for 2years. i just bought a house and did a 1am burnout and blew trans i think. it dont go forward or backward at all. assuming a trans line didnt break (i hope one did) ughhh.. is this a blown trans? I have a John Woods valve body...
  2. R

    Rear diff 10.25 locked up

    People are saying buy a used rear because 10.25s are 150-200 on average. It will cost you more than that in bearings (that are I think press on, press off), and then ring and pinion and required tools. Crush sleeve eliminator.. Then hub bearings. Id like to learn to set up diffs for fun. But...
  3. R

    HPOP Gaskets Leaking - \

    sometimes you think you know too much! like blaming an HPOP cause you got 2 more. I was going to order a new set of lines to be safe. Would I just be a cheapass to order...
  4. R

    HPOP Gaskets Leaking - \

    crazy.. swapped the line and it fired right up. sadly now I don't have the terminator in there and don't plan on playing with it for a few weeks. if you have an hpop leak like this and don't think its the lines.. maybe pull off the plastic insulation to see better. and to answer my own...
  5. R

    HPOP Gaskets Leaking - \

    Ok.. not ruling out injector o-rings yet but I have a few things 1st. The 3rd hpop wasn't leaking at 1st (maybe not fully primed?) but now an HPOP line (one with the 90 bend) is leaking. It could have all along but now its clearly leaking. I would think I'd of noticed this when it 1st broke...
  6. R

    HPOP Gaskets Leaking - \

    Ok well i got the 3rd Hpop in and no leaks but no start. 275 psi whil3 cranking. I checked which IPR was on it and its the junkyard IPR. The IPR % goes higher and higher, up to 50%. From what i quickly read, this sounds like IPR hanging? Sucks cause i used channel locks to remove IPR. Gonna...
  7. R

    HPOP Gaskets Leaking - \

    Truck is a 96 Btw. And my figuring would be the major leak is whats causing low pressure. Im also under the impression that if i were to fill the HPOP manually, the truck would fire up. I just pulled the fuel bowl and nothing stands out. I have a 3rd used HPOP out of a 97 Im going to swap in...
  8. R

    OBS up pipe collector

    pm sent
  9. R

    HPOP Gaskets Leaking - \

    That's what I was thinking. It's really hard to see everything with all the wires, lines and fuel bowl in the way.. But the non serviceable plug or the gasket wold be the 2 things I absolutely can't see. Original HPOP is crusty and covered in oil so it doesn't show any good signs of where it...
  10. R

    HPOP Gaskets Leaking - \

    Hey so seconds into a burnout my truck shut off. Oil was leaking heavily down the motor and it wouldn't restart. I quickly diagnosed it as some an HPOP leak. 200 cranking HPOP PSI. I wasn't able to determine where it leaked from and figured I could just swap a T-500 I bought on CL last...
  11. R

    New injectors....same issues

    Man that is a shame. I just swapped in Baby Swamps yesterday and the truck is a beast again. Did you buy all new Motorcraft sensors? One guy in the comments section of that video mentioned cleaning the ICP sensor contacts. (Ive fixed probably a hundred or so computers in my lifetime w/...
  12. R

    Injector Cores

    Thanks Jim. I was going to go with your injectors. The fact that swamps retunes your TS6 chip and being not sure of the condition of my core injectors (out of a random rusted out truck's motor), i went withthe swamps. Since my order ive read a bunch of your posts on different forums and your...
  13. R

    0 boost until 2000 rpm

    I was reading about CPS sensors earlier and the timing. Apparently not all CPS will just shut ur truck down. Maybe your CPS is wayyy retarding your timing. Anybody know if that's possible? My trucks only hitting about 20PSI but takes til like 70 to do that. Hoping new injectors fix that. I did...
  14. R

    So which converter and valve body?

    nice! I've been needing a new TC and just ordered baby swamps. Truck is LOW on power ATM and I can slip it if I try and launch. Which one did you get the 350/650 HP converter? I'm thinking of going with...
  15. R

    Transmission issues

    My 96 kinda runs like that. I think 2-3 or 3-4 is kinda rough but definitely smooth if you get on it. Also the shift at 40-45 drops to like 1200 RPM and loses all boost and takes a good while to get up to 50 where it smooths out. I've been thinking torque converter at 280k but I'm waiting on...
  16. R

    Injector Cores

    Hey all.. finally decided to drop some $$$ and get some new injectors. I bought a $300 7.3 motor w/ everything on it to use for spare parts/cores. But it was locked up at 1 point.. Maybe hydrolocked. 1 injector was bone dry when i pulled them. My question is has anyone ever had or heard of...
  17. R

    swapping a single injector

    Hey all if I swap a single injector, can I just remove that cylinder's glowplug and crank it over to get the fuel and oil out of the cylinder without removing the other 3 as well? I have 3 failed cylinders on a cylinder contribution test and just got 3 used injectors. I'm going to swap cylinder...
  18. R

    Cab sitting uneven

    Check out your front radiator core support mounts. Both of mine dropped and the fan started rubbing against the shroud. Bronco graveyard had the bushings but they were expensive. And then check the body mounts. My drivers side cab is rotted out and sits about an 1-1/2"-2" lower than the...
  19. R

    EBP sensor part number

    Just an update. I have the new sensor and tube in. Also had to pick up the manifold to tube adapter from a Ford fleet truck shop since the original was scrapped with the old manifolds (i chopped em up a little.. shouldn't of done it that in hindsight) I think its better than just unplugged but...
  20. R

    255/85r16, 33x10.00 Tires

    They would definitely look good on a dually. I've seen lots and lots of pics of duallies while searching for them. The Toyos do sound like the best option for a cool looking MT for the highway. Eating a set in 20k would be rough though. Like a nickel a mile rough. Like $1 in tire to go to my...

Random media

97psd2
Picture_153
IMG_3899
Resized_20180325_191839_6530
0A7E74F1-8800-45EF-AB66-3AC57020FFCA
Picture_065
Picture_064
The Truck
Big_Red18
image61
Lifetime warranty
header wrap to protect the airbag

Latest posts

Members online

Total: 352 (members: 1, guests: 351)
Top