Where is the best place to get a harley grill? I have a spare grill i painted black with billet inserts and it turned out really nice but if i can find one somewhat reasonable i will probably switch to that. Found one on ebay for 750 but thats a lot more than i want to spend on a grill..
Posting up a couple pictures of my truck. I painted the bumpers to match and pulled the lights apart and made them like the harley lights. i also painted the badges black and swapped out the stock vents with some stainless. i am going to get some stickers made for the f350 but i think they...
I am looking for recommendations for a new scan tool. I have an otc 3417 hd scan tool that is pretty much worthless and basically only reads codes. i am thinking about snap on but what all will they monitor?
Does anyone use one of these? http://www.elitedieselengineering.com/product/7C3Z-7A095-B/2008-Trans-Cooler/. my transmission is getting rebuilt right now and I am looking for opinions on this to see if this is worth getting? what else is needed to use this other than the cooler? thanks
I am selling my stock turbos off of my 6.4. they have 54,xxx miles on them and are in very good condition. I am looking to get 650obo. Selling them because they were swapped out for a single. I am also selling a set of stock uppipes that are off of a 2010 with very low miles. I am looking to...
I have a 6.4 engine that I am thinking about selling or parting out. I have it as a spare and am looking to sell. It has 104,000 miles and does not come with injectors, turbos, hpfp, or fuel rails. make me an offer. I am not sure what it is worth
Just posting a couple pictures of the 66mm single setup I fabricated and installed this weekend. It runs great even though I was worried about it being a little small. spools faster than stock, lower egts and it sounds amazing. currently using rcd 525 and it runs excellent! just need to get...
I have an 04 6.0 with 95,000 miles. It has just started running rough until it warms up since it has gotten cold here. I am thinking the injectors are sticking and I am looking for advice. Should i have them gone through and if so what who would be a reasonable company to have do this. I...
I have a 94.5 f350 that we swapped a 7.3 into. we have it running now but it wont accelerate and will only idle. the motor is a 94.5 the wiring is from a 95, underdash harness 97, pcm 95. There are two codes: po122 and p1661 which are low voltage input at tps switch
So far we have tried a new...
I am looking to get my transmission built in the near future and am looking for some input. I have heard lots of good things about suncoast and am thinking about getting there iron pac 3 kit and having a local transmission shop install it. i will also get either a suncoast or rcd torque...