Search results

I have carbon technologies for my Colorado build…. They are sweet. Sent from my iPhone using Tapatalk Pro

I trimmed it back to the main harness and made a new length of harness and soldered it back into the harness... I got a new connector from my Napa store echlin part # is EC89... it will plug right into the sensor... just get a wiring diagram and figure out what wire goes to each pin. Sent...

I trimmed it back to the main harness and made a new length of harness and soldered it back into the harness... I got a new connector from my Napa store echlin part # is EC89... it will plug right into the sensor... just get a wiring diagram and figure out what wire goes to each pin. Sent from...

Something like this Sent from my iPhone using Tapatalk Pro

I may be going to a aftermarket smooth grille Sent from my iPhone using Tapatalk Pro

Thanks for everyone’s help! Sent from my iPhone using Tapatalk Pro

Got my new engine done and got the turbos to operate correctly Sent from my iPhone using Tapatalk Pro

FIXED[emoji3060]. Ended up being the harness going to the ebp sensor... had the scanner hooked up to it and it was showing 4.95 volts... to high... I got underneath and wiggled the wires and boom it dropped right to .72 and the turbos spooled right up... when someone lengthened it they used...

Michigan Sent from my iPhone using Tapatalk Pro

And I had this issue the last time I ran the truck as well after is sat for a month Sent from my iPhone using Tapatalk Pro

It’s not that I’m leaking boost it’s the turbos aren’t even operating and are even trying to spool up Sent from my iPhone using Tapatalk Pro

So I took the dump pipe off the wastegate last night and no pressure is coming out so that rules out the secondary wastegate issue... so what’s next? I pulled out the ebp sensor and the tube both were clean... cheacked the map sensor again everything is good there... is it possible these turbos...

Yes the vgt is plugged in and moves as it should.... the truck did this the last time I started it before I pulled the engine for the rebuild. Sent from my iPhone using Tapatalk Pro

The vgt is plugged in and the actuator cycles when the key is turned on Sent from my iPhone using Tapatalk Pro

Never took anything apart when I pulled the engine... just undid the clamps and removed it Sent from my iPhone using Tapatalk Pro

So just got done installing my new motor and was hoping the boost issue I had the last time I started the truck before I tore it down was something wrong with the motor but It’s still not building boost. I did put a scanner on it and got code p2262 and p2263 which is a turbo performance...