Search results

Anybody point me in the right direction if any for putting in a good set of manual locking hubs? I am rebuilding the front end on my truck and have 1 bad hub so I am going to do them both. This winter put a hurting on my truck with all the snow plowing! I just want something priced decent, not...

Came out of an 04 F-450 2WD. 104K miles on it and worked great before the truck sat in a field for the last 2 years when the motor crapped out on the previous owner. Make offers/local pickup only!!! Also have a set of 05+ headlights. Great shape super clean! 150 plus the ride!

Ok this truck has a p0275 for a balance fault on number 5 cylinder. Took the injector out and swapped with #3 which is good and still same thing. #5 balance fault. The harness ohms out fine and within .1 ohm for each injector from the valve cover gaskets main harness. I am going to check the...

I am trying to trace down an injector issue in a truck and was wondering if anybody had a diagram for the large square ( I think its the 42 pin) connector that is on top of the driver side valve cover also for the IDM? I checked the resistance from the VC gasket side with injectors plugged in...

P0237 P0562 P1119 P1184 P1271 P1272 P1277 The truck was cold, been sitting outside here in the cold not plugged in. Got a killer deal on this truck so I bought it. It has a couple hundred miles on the injectors which are remans that the previous owner put in that he got off eBay from a diesel...

Tell me what you need and I'll see if I have it. The injectors have 53k, AA codes with new orings. I installed them last week and the motor ended up having a cracked piston so it never ran with them. VC gaskets and valve covers are good, Hpop is good. Tell me what you need. HPOP IPR will need to...

Anybody have any they can sell? Just need a working set for a truck I have.

96 not starting. Codes 344, 470, 603. Truck won't fire what so ever. Buzz test is good but nothing. Anybody help me out or have suggestion's? Truck has not ran in about 2 years.

Anybody know the part number for the Ford OEM full engine gasket set? Trying to find it to see what the cost is at a Ford dealer.

So I have a set of heads and was going to do springs and shims. Was thinking about valves also because the heads are not on the motor. What all is involved in actually doing the valves besides dropping them and putting the new ones in? Also what else would you all recommend me doing to the...

I tried to search and had no luck. Where can you buy a full engine gasket set? Everything but the VC gaskets is what I need. Does Ford sell them and if so does somebody have a part number?

I know this is on here somewhere but I cant find it. My exhaust is finally done for after 10 years. Just wondering what you guys use that holds up in the Midwest to the winters. DP all the way back. I am thinking 4 inch back but I like the 5 inch look just not seeing to many 5 inch ones...

Truck in sig. Its leveled out pretty much and I have a 285/70/16 on it. I have bfg All Terrains on it currently. I dont need anything for snow anymore, the truck is retired.from plowing and it does not go off road. I dont tow with it and dont drive it a whole lot either. Its going to get ripped...

What causes this on these motors?

I am curious about your valve springs and at what point you would recommend using them instead of the 910s. Also the S467, what are the limits on injector you have been seeing with them? I trying to get all this stuff figured out to start buying parts and I am going with a 250/200 most likely...

Just decided to come over to here from the nation and see what its like.