Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
New showcase items
New showcase comments
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Showcase
New items
New comments
Latest content
Latest reviews
Latest updates
Search showcase
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Power Strokes
7.3 Tech
1747 code,ebp sensor code help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="Dirtclod, post: 1435165, member: 20061"] Okay I'm transferring this topic from anyone ther thread and hopefully someone can at very least make some sense. All this happened after I plugged in an edge Evo tuner into my truck that was programmed for a manual transmission. Edge sent a Programmer to put my info back on my pcm and everything was fine. It ran normal for a couple weeks no problems. Then all of a sudden I'm getting this 1747 code (epc electric pressure control solenoid in the tranny) I checked the plug at tranny and there was fluid in it. I installed new solenoid pack since the oring was leaking. I have voltage at pin 1&12 on the plug. No short on the wh/y wire pin 11 at plug. Still had same issue. First thing in the morning I pull out in the road as soon as I give it throttle OD light flashes and shifting changes with less power. After I installed the solenoid pack I drove it to the dealership about a mile down the road and I had diagnostic run. Now I'm getting ebp sensor code. Reading 45 psi map14 bar 14. Cleared codes and upgraded computer. Yesterday I took ebp tube off it was clear but the sensor was clogged up and coupling. Cleaned the coupling and installed a new sensor from ford. Then it was worse. Now when OD light flashes there is almost no power. Before this I could drive anywhere as long rpm didn't get above @2800 and it did fine. Now not enough power to drive anywhere. My pedestal is d******. I found the wires to the pedestal shorted together. I cut the connector separated the wires and capped both off. No damage to see. 5 volts koeo at ebp connector. Plugged in after disconnected the grounds at batteries and I thought it was fixed. But after a couple miles it started again. I also noticed it used bout 1/4 tank of fuel tank n just a few miles of driving. No leaks and no smoke. But I can smell strong fuel smell while idling. 3 mechanics say it's transmission but transmission tech says it's wiring or pcm. What do any of you guys think? [/QUOTE]
Insert quotes…
Verification
Post reply
Random media
Latest posts
If you've had a 6.4 crack pistons please read
Latest: ncollins64
Yesterday at 7:08 PM
6.4 Tech
20% TO 40% OFF ON FORD OEM PARTS
Latest: HeavyAssault
Sunday at 3:43 PM
Sunrise Ford Parts
B
No Start help
Latest: bismic
Sunday at 9:58 AM
6.0 Tech
New torque converter locking up in Reverse and 1st gear
Latest: 6.0 Tech
Saturday at 11:12 PM
6.4 Tech
0
Dana 80 cab and chassis rear end
Latest: 03f3507.3
Friday at 2:11 PM
Engine and Drivetrain
Members online
cgoff1984
tangoparson
DEEZUZ
Raider4044
Forums
Power Strokes
7.3 Tech
1747 code,ebp sensor code help
Top