Reply to thread

Message: [QUOTE="Hotrodtractor, post: 318086, member: 25"] TyCorr nailed it. I built it it myself - I sourced all the machine work through a variety of shops depending on what I needed done - but I knew what I needed to end up with and shops got very specific instructions on what tolerances and where I needed to be when it was done. But my build wasn't any where near by the OEM repair book... it is a specific combination of parts and clearances that work as a unit - for instance - I can't remove my heads and install them onto another motor and expect anything other than a catastrophic failure - same goes for putting "stock" heads on the build short bock. [/QUOTE]

Verification

Random media

533856BD-3AA0-4426-A0D8-35A3958F8F45

Always changing to make it a home on the road.

Pockets

C1FA78A7-6562-4476-83FF-4308DB52AE3D

maple_grove_031

east_coast_hair

Always changing to make it a home on the road.

E1B2067A-B886-48E6-8696-6D218CC01E4D

loose_gearshift_bolts

110908-N-JH293-098

Latest posts

new build input welcomed
- Latest: btoler4th
- Today at 3:37 PM
6.4 Aftermarket
OEM LED sport headlights
- Latest: ghohouston
- Today at 8:37 AM
2017+ 6.7 Aluminum Super Duty
Gauge cluster face plates
- Latest: crash86
- Sunday at 5:15 PM
6.0 Aftermarket
B
6.4 head gasket job cost
- Latest: bowhunter
- Sunday at 2:07 PM
6.4 Aftermarket
S
6R140 surging issue
- Latest: Smokin 6.0
- Sunday at 12:11 AM
6.7 Tech & FAQ

Members online

ghohouston

Total: 768 (members: 1, guests: 767)

Top