Reply to thread

Message: [QUOTE="webb06, post: 1309617, member: 7680"] After getting the upper and lower oil pan off there was nothing obvious showing up. So I pulled off the main caps individually and still nothing. All main bearings looked great. Hooked the starter back up and spun the engine using that. There still seems to be a vibration in the engine just by using the starter. When I spun the torque converter by hand it makes an awful racket just by spinning as fast as I can with my hand. Also the front transmission seal was leaking because when I separated that engine and trans there was a small amount of fluid that came out. Any suggestions? Can a torque converter cause a vibration and noise not quite as bad as the video above? When the truck first came in we removed the lower plastic oil pan and found small slivers of metal in the bottom of the pan. That's what led us to believe there was lower end problems. Also this engine was replaced under warranty when the truck had 33k miles, now has 120k. Sent from my iPhone using Tapatalk [/QUOTE]

Verification

Random media

Hydroboost and power steering

6.7

Kazakhstan

2011-12-17_20-21-05_276

KC68mm

IMAG0578

Misc_V-Drive_559

2011-07-06_22-25-01_636

03 7.3 ZF6

Magneto_front

sctlivewireTS

for sale

Latest posts

D
‘10 6.4 rebuild
- Latest: Dieselnewb64
- Yesterday at 5:23 PM
6.4 Tech & FAQ
S
F-350 Dually tire size
- Latest: Smokin 6.0
- Yesterday at 5:14 PM
6.7 Tech & FAQ
Won’t start issues
- Latest: psduser1
- Sunday at 8:30 PM
7.3 Tech & FAQ
Windshield washer fluid reservoir
- Latest: psduser1
- Sunday at 8:27 PM
7.3 Tech & FAQ
F-250 & F-350 gear ratio question ?
- Latest: Mark Kovalsky
- Sunday at 6:57 PM
6.7 Tech & FAQ

Members online

6.0 Tech

Total: 436 (members: 1, guests: 435)

Top