Reply to thread

Message: [QUOTE="TARM, post: 102780, member: 578"] Big Bore, You would not need to use a secondary pump but could use a hose from the block to get your pressure as well you have what dumping from the IPR. You could then have that feed back into your stock res. The idea is that the pathway used to get the oil to fill the standard res tends not to keep up especially if you send IPR flow somewhere else (oil pan). So kill a few birds with one stone. Instead of sending the oil back to the pan and then only having the oil from a hose off the block supplementing the oil feed back to the HPOP res combine it all into a secondary or staged reservoir. Have IPR go there where it can settle. Also feed from the block to that as well. The mix will further lower the over all temp and will add the LPOP pressure to the tank. Then have a hose line feeding from that tank to the stock HPOP res. You get cooled air separated settle oil plus extra flow from the block. I am kicking around some other idea but this was something I had thought up to address some of the issues of the vol dual HPOP etc draw. I have not tested it thru or anything it had only made it to pen and paper at this point. [/QUOTE]

Verification

Random media

2013-01-31_21-06-33_882

Amp Lights

20140907_171124

new dash lights

IMG_20180915_170717432

eleanor_at_dereks_1_

High Pressure Oil Leak Problem

eleanor_part_two_33_

293941_214215245304283_100001474272705_597994_1362671332_n

Latest posts

GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Friday at 1:24 PM
Engine and Drivetrain
Hard steer question/issue
- Latest: psduser1
- Thursday at 8:52 PM
7.3 Tech
B
WTS/WIF light flash and stall issue
- Latest: blickcd
- Thursday at 6:23 AM
6.0 Tech
T
2013+ steering gearbox in older trucks
- Latest: TPOLO
- Wednesday at 11:09 AM
Suspension, Drive Train, and Tires
J
15 cab on 08
- Latest: jeretl
- Monday at 2:38 AM
Aftermarket Super Duty 1999 - Current

Members online

Powerstroke Racer

Total: 772 (members: 1, guests: 771)

Top