Reply to thread

Message: [QUOTE="1BADF350, post: 22215, member: 687"] Hey guys, sorry for the slow reply..been a busy past 2 days...These pistons are stock right out of the box (as far as I know) Once I get the donnor motor torn down in the next week or two and know what I need for crank and rod bearings. I will be ordering them and then sending the pistons out to have the bowls done and then from there, Im sending rod and main bearings along with the pistons to Swain Tech coatings for their PPM treatment and the tops of the pistons ceramic coated. This build is going to be a good strong tow motor since I pull a 44' enclosed trailer from Tn. to Ca. every 5 or 6 weeks. I will also be studing the mains and im thinking about making my own main girdle out of 3/4" or 1" plate steel. I know its overkill for a 500 hp tow motor, but im just goofing around with this build. I am going to be starting a thread in the correct area for "Project Pro-Tow" Soon and im looking for all the advise you guys can throw at me..Thanks again [/QUOTE]

Verification

Random media

2012-04-10_16-52-03_78

Line X the bed

my stufff

200_Fuel1

CNG Setup

IMAG0539

psa_camo_front

Interior

10200613685891940

SHAQ

Latest posts

GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Today at 1:24 PM
Engine and Drivetrain
Hard steer question/issue
- Latest: psduser1
- Yesterday at 8:52 PM
7.3 Tech
B
WTS/WIF light flash and stall issue
- Latest: blickcd
- Yesterday at 6:23 AM
6.0 Tech
T
2013+ steering gearbox in older trucks
- Latest: TPOLO
- Wednesday at 11:09 AM
Suspension, Drive Train, and Tires
J
15 cab on 08
- Latest: jeretl
- Monday at 2:38 AM
Aftermarket Super Duty 1999 - Current

Members online

drh4250

Total: 1,508 (members: 2, guests: 1,506)

Top