Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
New showcase items
New showcase comments
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Showcase
New items
New comments
Latest content
Latest reviews
Latest updates
Search showcase
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Power Strokes
6.0 Tech
Need some help, please.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="corder1979, post: 1538548, member: 32050"] I drove down to my girlfriend’s house last night, and my truck started acting up about five miles from her house. I just had the AC compressor replaced (it had seized up). I got it back on the 23rd, and had only put about 100 miles on it until last night. Aside from the shop forgetting to tighten down a couple of the turbo clamps on the pipe going to the inter cooler (which popped off and sounded like a shotgun, scaring the crap out of my kids and myself), everything seemed fine. The truck ran great, lots of power (as always), shifted perfect. i drove it to work several times and never had an issue. Then, I drove it to her house (3-1/2 hours away). I got off the highway a few miles from her house so I could fuel up for the trip back tomorrow morning. When I pulled off the highway and gave it throttle, as it shifted it was slamming into gear. I BELIEVE it was from second to third, but I wasn’t paying that much attention until it started acting up. It did this all the way to the gas station, then all the way to her house. It seemed as though it was a lot better over 50. Not sure if that means anything or not. I did do some searching and found the “5r110 Shift Relearning Strategy”, and I’m getting ready to go try that, since before the compressor replacement, I had unhooked both batteries and didn’t have a KAM battery (just found out about it when I was searching for my issue). I’m hoping that solves it, but is there any other issue that could cause this? I figured I’d ask now so I might have some ideas when I get back in from messing with the truck. I haven’t even put 2,500 miles on this truck since I bought it back in February, and I’m starting to think it hates me. As of right now, I’ve done the relearning procedure, and it seems to have worked somewhat. However, I don’t have overdrive, the truck is stumbling horribly and when I went to back up a little bit ago, the throttle decided it didn’t want to respond for a couple minutes and the injectors clattered a lot louder than usual. Then it took about 4-5 minutes to get from 0-30, then at 30, it finally started running correctly. The truck isn’t tuned, it’s stock. Since I’ve had it, it’s never overheated or even went over halfway on the engine temp, and always slightly under half on the trans temp. It’s not throwing any codes at all (no engine light). Rick [/QUOTE]
Insert quotes…
Verification
Post reply
Random media
Latest posts
If you've had a 6.4 crack pistons please read
Latest: ncollins64
Monday at 7:08 PM
6.4 Tech
20% TO 40% OFF ON FORD OEM PARTS
Latest: HeavyAssault
Sunday at 3:43 PM
Sunrise Ford Parts
B
No Start help
Latest: bismic
Sunday at 9:58 AM
6.0 Tech
New torque converter locking up in Reverse and 1st gear
Latest: 6.0 Tech
Saturday at 11:12 PM
6.4 Tech
0
Dana 80 cab and chassis rear end
Latest: 03f3507.3
Friday at 2:11 PM
Engine and Drivetrain
Members online
JSalamaDO
towerrigger
Porqchop
hermantile
Sterling6.7
JoeDiesle
Joush
Mark Kovalsky
Forums
Power Strokes
6.0 Tech
Need some help, please.
Top