Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
New showcase items
New showcase comments
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Showcase
New items
New comments
Latest content
Latest reviews
Latest updates
Search showcase
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Power Strokes
7.3 Tech
P1280 icp code
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="Ckaas13, post: 1561409, member: 34920"] I've got a 2000 Excursion with a P1280 ICP circuit low code that is stumping me. It started with a hard start/long crank and led into a running rough/no power. Inspected ICP sensor and connector and found damaged sensor and oil contamination in wiring pigtail. Replaced both with a Napa brand sensor and connector. Cleared codes and retested. Found code is still there. Plumbed in gauge to oil reservoir and checked low side oil pressure while cranking, found 50 psi. Plumbed in gauge to fuel filter housing and found base fuel pressure to be 60 psi while cranking. Found a ICP troubleshooting pinpoint test. Tested VREF and signals too ICP connector and found within spec. Disconnected PCM and ohm checked engine harness to PCM and found no issues. Monitored PIDS using FORSCAN. During cranking ICP is at 600 PSI, IPR is at 32%. After cranking for 65 seconds Engine finally started. ICP at 693 psi, IPR is at 28%, engine at 800 RPMS, total run time 1.5 minutes. If I shut the engine off and immediately try to restart it just cranks for probably 2 minutes and then starts but runs rough and tries to die. Im suspecting there is a short in the PCM itself but I would like to verify that for sure before I replace it. Any thoughts or suggestions? [/QUOTE]
Insert quotes…
Verification
Post reply
Random media
Latest posts
10R140 failure
Latest: PSD-BLACK-CLOUD
Today at 1:04 PM
2017+ 6.7 Aluminum Super Duty
2010 headunit
Latest: glog
Wednesday at 1:17 PM
6.4 Tech
D
Turning off the Auxiliary powertrain control module
Latest: donaldtfreeman
Tuesday at 10:43 AM
6.0 Tech & FAQ
4r100 P0715/P0717 trouble codes.
Latest: Tiha
Tuesday at 8:07 AM
7.3 Tech & FAQ
I must be getting old… Exhaust is too loud
Latest: ju015dd
Sunday at 7:59 AM
6.0 Aftermarket
Members online
No members online now.
Forums
Power Strokes
7.3 Tech
P1280 icp code
Top