SaltySteve
New member
Hey guys, I was running down the road and got a trouble light with a pic of a wrench..She started running rough after . I restarted the truck and running fine.. What was she trying to tell me?
Steve...
Steve...
Problem??
- Thread starter SaltySteve
- Start date
Sterling6.7
Well-known member
- Joined
- Oct 9, 2014
- Messages
- 1,451
- Reaction score
- 70
Did it make any beeps from the dash before shutdown? Did you count them?
SaltySteve
New member
I don't recall any beeps, if it made any it was only 1 or 2. Just a gold square with a wrench in it and wording that said basically see your owners manual. It immediately started running rough, like only on 6 cyls or something like that. It didn't seem to slow me down though, I was in a 45 zone and was able to do that at least. Once I got into a parking lot I restarted it and everything was normal. I am getting a scanner tomorrow so I will see if there any traces of the code it should have created.
Sterling6.7
Well-known member
- Joined
- Oct 9, 2014
- Messages
- 1,451
- Reaction score
- 70
Ok. Just making sure you were paying attention. Need to read the codes, if there are any left. Were you pushing it hard?
SaltySteve
New member
Not at all. I think my grandma would probably drive it harder than I do.
It's my only vehicle and I baby it.
It's my only vehicle and I baby it.
SaltySteve
New member
According to my new scanner, there are no active codes. I guess it was just a fluke.
PDT1081
Well-known member
What scanner?
