Reply to thread

Message: [QUOTE="PowerstrokeJunkie, post: 253120, member: 230"] I take a thick steel rod that will support the engine's weight and run it between the two lifting eyes, then chain from the center. Get the head of the cherry picker in as close to the bar to enable you to lift the engine up as much as possible before the engine hoist gets very near the wiper cowl. Almost all the time you forget about the wiring harness that runs across the wiper cowl below the hood seal, and something almost always snags the plastic and cracks it. Pull the little push pins out and get that out of the way. There is also a ground strap from the heater box area going to the rear of the passenger side head that most first-timers forget to remove, its a 10 or 13mm bolt head depending on the year. I remove the hood, just to get it out of the way and it lets a BUNCH more light in [/QUOTE]

Verification

Random media

trucks1

97psd4

wiring diagram

IMAG0455

dualIPRports

old trucks

573

2011-10-21_12-21-46_976

John Deere 110 vs X728

Latest posts

B
6.4 head gasket job cost
- Latest: bowhunter
- Today at 2:07 PM
6.4 Aftermarket
S
6R140 surging issue
- Latest: Smokin 6.0
- Today at 12:11 AM
6.7 Tech & FAQ
Won’t start
- Latest: psduser1
- Wednesday at 11:33 AM
7.3 Tech & FAQ
GT37 Turbocharger w/10 blade turbine, billet comp.
- Latest: hskfab
- Jun 6, 2025
Engine and Drivetrain
Hard steer question/issue
- Latest: psduser1
- Jun 5, 2025
7.3 Tech

Members online

No members online now.

Total: 306 (members: 0, guests: 306)

Top