Reply to thread

Message: [QUOTE="kleake, post: 1458352, member: 25987"] Ouch! Advice taken, my local dealership will have 2 new heads, 2 new sets of rockers (just to be safe), 3 new push rods, and a full set of valve bridges here tomorrow and will take care of the warranty on at least the heads and rockers. Unfortunately the push rods and valve bridges will be out of my pocket, however I will be talking to them about the labor involved. They are supposed to cover up to $150 for the labor involved in a warranty issue so that may offset the cost of those. Still not as good as I would like, but at least I should be starting with a correct set of heads and be back where I should have been 9 months ago. You can bet I will be double and triple checking everything on these before putting them on, especially valve stem height. And then once they are on, I will be doing a compression check, leak test, and interference check on every cylinder before I slap a valve cover on. [/QUOTE]

Verification

Random media

F250_Cropped

2004 ford f350 6.0

jeep_front1

front view2

2006 F350 KR Utility bed

DP-Tuner Timing

Latest posts

A few turbo questions and a rant
- Latest: powerlifter405
- Today at 12:08 AM
7.3 Aftermarket
Stage 2 LPFS for a 6.0 Powerstroke
- Latest: powerlifter405
- Yesterday at 11:58 PM
Engine and Drivetrain
0
6.7 pump with DD fuel bowl delete for 6.0. All lines and fittings with Rudy's drawstraw
- Latest: 06Mike
- Yesterday at 2:44 PM
Aftermarket Performance
Florida...
- Latest: Mark Kovalsky
- Wednesday at 10:22 AM
Southeast US
American made up-pipes?
- Latest: Powerstroke Racer
- Wednesday at 9:03 AM
7.3 Aftermarket

Members online

No members online now.

Total: 1,290 (members: 2, guests: 1,288)

Top