Search results

  1. S

    Truck down. I repeat. Truck down.

    Sounds like someone was hot roddin !!
  2. S

    2005 CCSB fuel tank question

    Nobody tried this?
  3. S

    2005 CCSB fuel tank question

    I have a 2004 CCSB that I believe the fuel level sensor is taken a **** on. It gets below a half tank and will go up and down. It went back up to a half tank the other day and I ran out. I think I’m gunna have to pull the tank and replace. My question is has anyone ever put a 38 gallon tank in a...
  4. S

    Steering play question

    Has anyone rebuilt a steering gear box ?
  5. S

    Clunking noice coming from Transfer Case?

    Also could be coming from the output to the front axle
  6. S

    Clunking noice coming from Transfer Case?

    Take the driveshaft out and see if you can wiggle the output from the transfer case and see if it wiggles ag all I have had bearings in the t case go out and cause this same situation
  7. S

    No start, everything as it should, head scratcher

    Looks like he said 34% on IPR
  8. S

    Carrier bearing question

    Yea it probably would but I drive the truck 3k to 3500 miles a year so a new carrier bearing will last me.. I suppose I will just pull it down and see what I got
  9. S

    No high end power

    May check for a air to air leak
  10. S

    Steering play question

    I’ve got a 05 CCSB that I just put 33’s on and now I have alittle sway in the steering. I think I may have had it before alittle but now I really notice it I’m. It a suspension guy. Is there any steering component imperticular to look at for this issue ? I’m thinking of putting a dual steering...
  11. S

    Oil pan leak !

    Yea no kidding it’s a $35 OEM gasket that cost $1200-$1500 for the dealership to do. No thanks I’ll do it myself.. thanks 6.0 tech
  12. S

    Oil pan leak !

    Has anyone replaced the gaskets on a oil pan with the motor still in the truck ? Just curious on how difficult it is and a estimated repair time.
  13. S

    Carrier bearing question

    I’ve got a 2005 CCSB F-250 need to replace the carrier bearing or center support bearing whatever you want to call it. Would like to do it quickly and have the parts on hand before tearing into it. Does anyone know the shaft size ? There are a few options and they appear to be fairly close
  14. S

    6.0 starts and dies

    Yea sorry I was on vacation. Must have just been my luck but the fuel pump went out and I changed it still had a crank no start checked IPR % on crank it went to 85% so I used my IPR air pressure test fitting turned out I had a hug pressure oil leak also. Pulled the standpipes and dummy plugs...
  15. S

    Radio question

    Anyone ?
  16. S

    Radio question

    I’ve seen a few radios that have 3 plug ins on the back and a few with 2 plug ins on the back and also that have the antenna plug in that are either male or female. Does anyone know off top of there head if a 05 with steering wheel controls has 3 or 2 plug ins on back ?
  17. S

    OEM 6CD Radio 5C3T-18C815-CB

    Can you tell me what shipping to 46076 would be ?
  18. S

    Fuel pressure question

    Ok just wanted to make sure I wasn’t over looking something thank you
  19. S

    Fuel pressure question

    On my 05 when I key on the fuel pressure builds quickly to around 65psi truck starts and runs good fuel pressure stays good.. when I shut the truck off the pressure drops to 0psi pretty fast isn’t there something that keeps it from dropping that low ? Like a check or something I don’t ever...
  20. S

    6.0 starts and dies

    If I idle it up to around 2500rpm for a few seconds it drops right down like it should and idles normal no lope think it just needs to run awhile.. I didn’t think there would be that much air

Random media

New Two Tone
donor_harness_1_
donor_harness_3_
IMG_20150328_153726746_HDR
2012-04-06_12-35-14_805
image120
IMAG0455
image299
Mishimoto radiator
Snapchat-20140602093945
image135
Branch_Tube

Latest posts

Members online

No members online now.
Total: 439 (members: 0, guests: 439)
Top