6.0 up pipe solutions for Steed Speed

Cutting-Edge Diesel

Active member
Joined
Feb 10, 2012
Messages
5,738
Reaction score
0
Location
Newkirk, OK
updated pic

783-BF07FF250957-5255-000004C9B28E4931_zps1704cb0c.jpg


clearance
14D-78A49E652FD4-5255-000004C4B64B8D80_zps0ce860a2.jpg
 

SEABEE08FX4

New member
Joined
May 18, 2011
Messages
7,463
Reaction score
0
Location
Montgomery TX
See now this is what I was asking about in a few other threads, seems like this would be the better solution to running these. I dig it good job.
 

TooMuch03

New member
Joined
May 3, 2012
Messages
656
Reaction score
0
Location
West Bend, WI
well everything I have on steed speed will be put on hold untill I figure out if he is going to start producing 2'' manifolds. It sounds like that is what he is going to start doing after our talk this morning. Unless you already have the 2.5 manifolds and want to use them.

That would be really awesome if the steed speeds were 2" instead of 2.5"
 

windrunner408

New member
Joined
Jul 27, 2011
Messages
1,496
Reaction score
0
I'm not an expert in gas flow or anything but it just seems to me that by having the little 2.5in bubble built in right there at the back and for the turn before reducing back down to 2in is actually a good thing. I know its a pain for make up-pipes and what have you and I wouldn't want to use 2.5in up-pipes the whole way up but it seems to me that by having that little bubble/chamber (or whatever else you want to call it) you are allowing the exhaust gases coming out cylinders 7&8 to have some room to expand flow out to help equalize the pressures on all of the cylinders. Perhaps if he starts making the manifolds with 2in outlets for the 6.0, he'll redesign the angle on how the gases from cylinders 7&8 enter the mix. Either way, I'm interested to see what he comes up with.
 

Latest posts

Members online

Top