Scangauge?

I got the scangauge from Terminator Engineering and was wondering if I can just hook up the OBDII conection and it will work or will I have to get power from the optional three wire connection? Sorry for the dumb question but I thought I would ask the Army profesionals.

It will work, at least mine did.

Thanks, I'll try in the am.

It should work just fine with just plugging it in.

Mine works just plug it in and have fun. You'll like it.

sweet, works perfect!

Could it be that the aux power line kit is for when you hook up the external sensors

Exactly. Especially when you add more than one external input.

ok, did buzz test last night and it passed. i tried to do the contribution tests and it came up with three codes p0269 no. 3 cyl fault, p0284 no. 8 cyl fault and p0541 manifold heater (mines deleted, might need to put a resistor in there). could this be a faulty cam shaft sensor issue?

do the cont. test a couple more times mine did the same second time a did it i got nothing as well as third time

ok, i'll try it. does the motor have to be operating temp or cold when you do this test?

not sure maybe wait a lil bit before trying it

Motor has to be hot for contribution test. I think 3 and 8 are the grey CPS deal.

bad thing is i have a black cps? its about 2 yrs old though.....

i do have a spare used cps that was good when i swaped in the new one. i swaped it because it was cheap and i was trying to track a problem down and the problem ended up being a loose chip connection.