Recent content by 1BADF350

And just a quick heads up, yes I know the AC are single shots, Jody will be doing a live tune within the next few weeks when I get over his way. But the work trucks will retain the split shots. but will also have Joeys T-500 HPOP installed.

Hey guys, I have a question? I put in a brand new set of AC code injectors in my wife Excursion that I got from Jim at Rosewood diesel, So I now I have a set of the stock injectors they have a 170,000 miles on them. Question is, Can I just put new orings and crush washers on the and put them in...

@dieselboy, already been soaking all the exhaust bolts in pb blaster and also have a can of Aqua net hair sray, lol!! @strokeorcroak, Brand new 160cc Single shots, not remans. Luckily my weekend starts tomorrow (Thursday-Sunday) and then next week I will drive excursion down to Jody @ DP...

Looks like a busy weekend is about to begin, New Single shot Injectors, T500 HPOP upgrade, new IPR and ICP. New Valve cover gaskets and UVC harnesses, New thermostat and Billet Housing with extended life anti-freeze, coolant filter base and spin on filter, New Diesel site intake boots, Bellowed...

Thanks Guys, I just ordered a 5 gallon bucket from DP.. :thumbup::thumbup: now I just need the weekend!!

Does anyone know whicjh of the vendors sell this in the 5 gallon buckets? I saw them the other day but now cant find them.. need for BTS nstall this weekend.

yes, those are them them, thank you.

PM me a price please.

I have a set of the bellowed up pipes from International, but the other day I saw a picture of a 1-piece bellowed up pipe assy that had either a high heat coating on it or was made of stainless steel. Anyone know who made this piece? I like to price one out before I install these.

Is this long block still avalible?

Hotrodtractor, How far back have your bowls been cut? What does it cost to have the edge removed or if for a stock build, can this be done at home with sanding rolls?

Yes, rods will shot peened and then sent to 300below.com for cryo treating. along with some other items on another motor im building to make the weight requirement.

Hey guys, sorry for the slow reply..been a busy past 2 days...These pistons are stock right out of the box (as far as I know) Once I get the donnor motor torn down in the next week or two and know what I need for crank and rod bearings. I will be ordering them and then sending the pistons out to...

I just think an engine only forum would be a place we could discuss and share ideas in building these powerhouses? just an idea. To me the Project forum is a broad arena. Being item specific would allow more technical talk..

BAHAHAHAHAHALOLLOLLOL