Recent content by greenman01

Thanks for the comment bud!

Head studs are sold. Billet wheel is still available.

Still for sale

When I reinstalled the turbo I didn't realize that the dowel wasn't lined up with the collector. So I pulled the turbo again, not yet knowing of a huge exhaust leak and put the stock 38r wheel back in. Buttoned everything up and didn't line it up again. I really didn't feel like pulling the...

7.3 ARP head studs I bought these off another member a while back and never used them. They are new in the box. $425 38r Riffraff Billet Wheel I installed the wheel once, properly, on the bench. Removed after 5-10 miles. $125 Located in BC, Canada Prices are in US dollars

Sold.

Yup, you are right :doh:. We've always used FF105's as a primary on the old 3306B's and I thought it was a water separator. I'll be switching them to 1212's in the future.

Wrong. The FF105 is a water separator. If you want a primary filter with a drain then switch to an FS1212. It will fit the same filter head as the FF105.

Yes. That info was from Dennis at Strictly.

Fuelab at half speed has been reliable and way overkill for my setup. Keep in mind you have to run a BF1252 primary, not a 1212.

Still for sale. $2200 shipped.

Me neither

Where did you mount the amp? Will it fit under the seat? I don't want to lose too much space behind the bench.

If you're not reusing the hardware then this is the best way. Either break the heads off or use the hot wrench.

I smoke out the neighborhood in the winter with the truck in my sig. I had a no start in the economy tune a few weeks ago at around 30. It would just romp a few times and die. I tried to start it in the street tune and it flashed right up. Also using 15-40.