Recent content by jpow95

By hand Sent from my iPhone using Tapatalk

Pull the glow plugs out and see it’ll turn over Sent from my iPhone using Tapatalk

Thank you for the info everyone Sent from my iPhone using Tapatalk

Ending up finding a bad cam sensor wire in the harness Sent from my iPhone using Tapatalk

Ipr is up at 40 Sent from my iPhone using Tapatalk

Swamps was 3 weeks out to build the injectors so we went this route icp is up at 2200 Sent from my iPhone using Tapatalk

I had the original 250k in and it ran great then had it stall out then installed new injectors and still a crank no start possibly a air lock in the fuel system Sent from my iPhone using Tapatalk

I also would like to mention I do not have a wait to start light but can communicate with pcm and also I swapped pcms with a new one still same problem and still no wait to start light Sent from my iPhone using Tapatalk

I did replace with ford oem and still same issue sounds better while trying to crank but still no start unless a gasrag is held up Sent from my iPhone using Tapatalk

Getting black smoke like little puffs smoke and sounds like it’s firing only on a few cylinders I drove it to 45miles no problems next day it drove 2 miles before stalling then added the new injectors and hydra chip for the injectors then drove 2 miles before stalling now I’m just getting black...

I do apologize for double posting I didn’t see it post the first one Sent from my iPhone using Tapatalk

Changed idm with known working one still issues did get it started but will only drive about 1 Mile before shutting down and getting a no start again did install new 160cc injectors from black cloud and ran great for about a mile now getting p1272 -p1278 codes going to ohm the injectors then to...

Icp 1500 Fuel pressure at 58psi New cam sensor Fuel pulse .60 If I hold up a gas rag to the intake it will fire off to start but will not run under its own power getting black smoke from exhaust anyone ever run into this Sent from my iPhone using Tapatalk

Yes found issues with new ball tubes install hhc ball tubes no more issues Sent from my iPhone using Tapatalk

Did a motor swap in a 02 7.3 to another 02 7.3 installed motor and will crank no start ...icp is at 1500 and fuel pressure at 55 and fuel pulse is at .60 ms .. getting a slight bit of dark grey smoke and the glow plugs are coming on but I am not getting a wait to start light the fuel bowl heater...