Recent content by Smokun

CheckEVAPtempsensor Sent from my iPad using Tapatalk

This may sound odd but disconnect the batteries for about five minutes and reconnect. Mine has done thisTo me numerous times Sent from my iPad using Tapatalk

Your high and low side pressures would be helpful as well. When it is working properly, and then when it’s not working properly Sent from my iPad using Tapatalk

I don’t know if this may help or not to anyone but I have seen the evap temp sensors going bad a lot on these. I don’t do Evaps without replacing sensor nowadays. Sent from my iPad using Tapatalk

Old turbo was stock dual inlet turbo. When I say run out of fuel I could not hold rail pressure with the stock turbo. With my file now I can maintain real pressure without any p-0087. I don’t quite get what you are asking about a turbo not making it run out of fuel but I work on gas engines and...

I recently bought a prototype turbo kit with piping from pusher intakes for my truck. It’s a 366/80/.91- I haveThe standard non-Vgt file from my tuner. My question is should I be dialing this in more than just a standard tune. Fuel is stock and is a 14. It runs good. It does not run out of fuel...

CHANGE YOUR OIL. Ther is coolant in ther Sent from my iPad using Tapatalk

Remember if your truck idles a lot it will eat away at your fuel mileage indicator. I average around 12 in town and I drive like a dick. 17 on the highway driving sain Sent from my iPad using Tapatalk

It’s not only about the lip of the seal folding over nowadays. They put the seal in at a certain depth and if it’s not absolutely correct it will leak. Sent from my iPad using Tapatalk

Brake hoses Sent from my iPad using Tapatalk

I had To do this recently for a customer. Being that it is hidden behind a fender well we cut an access hole a little bigger than what’s there. Then we cut the opening a little bigger and slid the cage out of the tube. On the install we just held the nut with a wrench. Sent from my iPad...

Disconnecting both batteries for five minutes should also do it and if you disconnect both batteries and make sure both are disconnected then put positive to negative on both sides holding together for about a minute that will do a master reset on that vehicle as well. It will reset all...

Yes that code should go away. On forescan you have to hit the button on the bottom just to the right where they look almost similar. If that code came up and did not clear that would mean it is unplugged or something went wrong with the clearing process because that will use a two or three...

Your temp sensor codes are from overheat. That’s normal. Oem is the best option I believe as well. Thermostats always a good idea after overheat. These trucks have the capacity to get big air pockets in them so be careful to make sure your cycle The heat and let the truck go through a couple...

Normal. I would not be concerned that’s what the magnet is there for. Almost any tranny service I do the magnet has some stuff on it just normal wear and tear. One thing you may want to do is reset the adaptations and then do a re-learn Sent from my iPad using Tapatalk