Recent content by swamp_ratt

Does anyone know the stroke on the slave cylinder? Like the actual usable stroke? I'm trying to figure out geometry for a trans swap I'm doing to use the zf hydraulics. Thanks

I still have everything left. Needs to go ASAP. Buying a house and don't want to bring a bunch of crap with me. These need to go or I'll scrap em in a month

Bump. Last offer or I'm going to scrap it all. Need this stuff gone

The latter two pictures are more what I'm interested in. Was just curious on how it might fit. I already have the turbos I'm using, do not buying a kit. Not to mention I'll have FAR less money into a compound setup than any kit

Going to be doing compounds on my truck, but not sure the best way to go about it. Looking for pictures of good compound setups while keeping the HVAC system intact. Been scouring the web and not finding much of anything useful. Anyone have anything?

On an 06 super 60 (f550) does the short side axle shaft have a clip in the differential holding it in?

Bump

Bump, still have these motors that need to go asap

Hey, if it masks it for about 6 months, that's all I care! It pops out of 4th gear coasting once it warms up. Cold it doesn't do it. Only done it since my engine swap

What does everyone run for fluid in their zf5's? I'm going to be changing the fluid in mine chasing a 4th gear issue. Typically I run bar and chain oil in my manual transmissions. Interested in what all you have found works well for you

Who would be someone reasonable to do custom injector cups for a 7.3? Kinda messing around with a few ideas... thanks in advance!

Bump. Want all this stuff gone

I'm not an electrical person! Hence why my motor has a p-pump! So yeah, I'm asking where keyed power is for my own reasons. What it might be for could be completely irrelevant! What does it matter what I'm asking for the locations for? Don't need smart ass remarks, just answer the question or...

Apparently you didn't read my signature...

Is that going to be the same or similar for an OBS?