Search results

Just talked to pacific fab. Going to work on a plan for the hydro assist kit with a rebuilt box, new pump, lines etc and a correct ram for the 2008 axle. Hope to have it to them on weds next week.

Finally getting off my butt to get this done. Awaiting a reply from pacific fab. Anyone else in the NorCal area in case they are a no go?

No not yet. Been slammed with work. Havent had a time to figure it all out. I am suprised that with how bad our PS pump is, that the PS pump upgrade from PCS isnt more common with our trucks...

Hey ya. Have had your tune for a while now. Have since lifted the truck, went from 4.10 gears and stock tires to 4.88 gears and 37's. I am also thinking about ordering a srp1.1 hpop, as the truck feels like it is running out of breath above 2300 rpm. (which I see a lot now with the new gears)...

Looking to do a PCS hydro assist in my truck. The full kit, new pump, new box etc... Looking for a shop that has done it... I have a 2002 truck but an 08 axle, so would need to order the ram for a 2008 throw. (not sure if its any different) Dont want to go to a shop where my truck is the...

Spring rates...

What length and rate are you guys running on your front coilovers. Also what size lift. I'm trying to sort mine out and am taking a census. Thanks!

Damn I neeeeeeed one of these... your Lights or hpop first....dang it CT, stop confusing me like this....

Whose bumper?

Or rather, his!

Theirs :naughty:

Yeah, The rear tops could have been flipped to the rear so I have been told. They say it would add a little extra travel and change how the spring rate hits. The rear is soft as it is now though. Wont change anything unless it breaks...which I doubt. The fronts are a bit stiff and bouncy still...

Front: or rear:

Just shot him an email to see how they are coming along!

Well, 1-Front locker 2-rear locker 3-air compressor 4-front spots 5-front fogs 6-back up light 7-Right side light (diffused Rigid D2's for camping) 8-Left side light (same as above) 9-Bed light (inside truck shell to check on dogs while driving)

Love to know if anyone can find a salvaged 6.4 truck that I can use for my swap... Can't find anything out my way

We have emailed. He said they were a pain in the butt. I'm just wantin toys! I knew they would take a minute.

I can't wait! My order through riff raff unfortunately still says "back order may 15th" I am going to put a volt and air pressure gauge in mine like the photo and then the other 3 typical gauges in a pillar mount. I have my 9 switches sitting on the table... Still saving uP for the lights that...

Hey all, anyone have the f650 dash with 9 switches? I have one on back order and am just sitting here bored. Trying to imagine what it looks like. Anyone have one installed (other than the pics from clays site)? Thanks