Search results

OK good to know. Thanks

Hey all. Sorry for the late follow up. Turns out the TC was nearly locked up internally. Would barely spin with the shaft. Installed new TC and slipped right on as it should. Tranny installed and all is well with it. Shifts nice and runs around 130* unloaded on the freeway so far. I have another...

Help... I cannot seem to get my TC in all the way. It is as far in as it will go while spinning back and forth etc. I get a measurement of 1" from bellhousing to flat area surrounding studs but the "nose" sticks out 1/8" past bellhousing. Is this correct? Some info I have seen says the "nose"...

I got it. Outer thrust bearing was not seated properly.

Hi all, Newbie here. I am in process of rebuilding my 4r100 and cannot get the output shaft snap ring to go on. I cannot even see the grove where it goes after the rear planetary ring gear and bearing are installed. I am positive that the output shaft is in all the way. Few taps on a block of...