Search results

Help... I cannot seem to get my TC in all the way. It is as far in as it will go while spinning back and forth etc. I get a measurement of 1" from bellhousing to flat area surrounding studs but the "nose" sticks out 1/8" past bellhousing. Is this correct? Some info I have seen says the "nose"...

Hi all, Newbie here. I am in process of rebuilding my 4r100 and cannot get the output shaft snap ring to go on. I cannot even see the grove where it goes after the rear planetary ring gear and bearing are installed. I am positive that the output shaft is in all the way. Few taps on a block of...