Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
New showcase items
New showcase comments
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Showcase
New items
New comments
Latest content
Latest reviews
Latest updates
Search showcase
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Power Strokes
6.0 Tech
6.0l short block
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
[QUOTE="youngstroker, post: 499146, member: 1918"] it is an idea i have been kicking around for a while, the plan is to put it in a ranger. -truck 1993-95 reg cab step side 2x4 -engine 6.0l -trans 4r100 -rear end 9" -hp goal 550-600/ whats needed to run the 12.0 index class, at first then we will see. i want a older ranger with the twin i beam, i think it should be easier to make it hold the weight, then a torsin bar system and a pre 1996 so i don't have to emmisons test it, so i can drive it on the steet. i already have a 1990 ranger that is juck and a 4r with a broken tail shaft houseing. i plan to do some mock up on this first to see how it will fit before i invest a lot of money in to this project. it will be built in stages first just put a 6.0/4r in a ranger at stock hp level and work all the bugs out manual steering and brakes no intercooler then build the truck i want from there air to water intercooler in the bed radiator in the bed if theres no room in the front, roll cage, put in a stout 9" with sliders, springs pulled in under the frame so i can fit a wider tire, i don't want to back half it but if need be so be it. possible a bed mounted turbo, if the hight of the motor is too much for a body lift and cowl hood. and most importantly a lot of suspension and frame work. i plan to buy a wrecked super duty and transfer everything over, hopefully have a lot of useable parts for my 03 superduty and then use the motor and haness to to swap it in to the ranger. [/QUOTE]
Insert quotes…
Verification
Post reply
Random media
Latest posts
B
7.3 lift
Latest: Bmcgarvie
Today at 11:48 AM
7.3 Aftermarket
6.4L Ring End Gap
Latest: ncollins64
Thursday at 7:02 PM
6.4 Aftermarket
7.3 fan clutch noise
Latest: OBS-Addiction97
Thursday at 5:01 AM
6.0 Aftermarket
6
Why do 6.4 rocker arms wear out and 6.0s dont?
Latest: 6.0FinnaBlow
Wednesday at 9:00 PM
6.4 Tech
T
Mini Max Tuning
Latest: tom6mn
Wednesday at 4:23 PM
6.7 Tuning
Members online
eng53ine
Forums
Power Strokes
6.0 Tech
6.0l short block
Top