airdog II install how do I bleed the air?

[onebadf150]

In the instructions in says to loosen the bolt on the engine to let the air out once the key has been turned on. My question is which bolt I'm assuming they are talking about the low pressure test port on the cooler but how do I use it? any tips or trick would be greatly appreciated!

Nick

 

[Powerstroked162]

I've always pre-primed the filters with fresh diesel and cracked them on the base until the pump purged the system and primed up....

 

[onebadf150]

I found this article on the internet
http://wpnet.us/Fuel_System_Bleeding_LP.pdf

would this tool work otc 7211
http://www.tooltopia.com/otc-tools-...m=cse&utm_term=OTC7211&utm_campaign=nextag_r1

 

[onebadf150]

could i use the key cycle method like when changing the fuel filters on a factory setup to get the air out?

 

[CT9AIX]

I just used the key method about 15 times, opened the drain valve on the filter, did the key another 4 or 5 times and never had any issues. When I change out the filters I also use the same method, the key cycle only about 6 or 7 times.

 

[onebadf150]

Thanks for the replies!